ENDON 91781 Floor Light Instruction Manual
- June 6, 2024
- ENDON
Table of Contents
ENDON 91781 Floor Light
INSTRUCTION MANUAL
Safety Warnings
- This product is only suitable for connection to a 220-240V~50Hz supply. It is for indoor use only, and not suitable for a bathroom location.
- Under no circumstances must this lamp be covered with any material as this could pose a safety hazard.
- Allow 10 minutes to cool before replacing, adjusting or cleaning.
- Clean with a dry cloth only. Do not use liquid or abrasive cleaners on this product.
- If the mains cable becomes damaged it must only be replaced by a technically competent, qualified person.
- If you are in any doubt about your competence please consult a qualified electrician.
- If any modification is made, it will invalidate the warranty and may render the product unsafe.
Assembly/ User Instructions
Before you start please read these instructions carefully before fitting and retaining for reference Check the packaging and make sure that you have all the required parts. Follow each assembly step in order to prevent incorrect assembly. Ensure that the product is fully assembled as illustrated before use.
These assembly diagrams are intended as a guide – if in doubt consult a
qualified electrician.
-
Do not attempt to plug in or use this product until it has been fully assembled. Disconnect from mains during assembly or maintenance.
-
Carefully remove all packaging from the base section, central tubes
Screw tube A onto Tube B in a clockwise direction. Take care not to trap the cable or cross the thread. Then screw Tube B onto Tube C in the same way. -
Gently pull any excess cable through from under the base and then out through the side of the base. Screw the base onto the assembled stems, turning in clockwise., Ensure that the cable will straighten when the tubes are fully assembled tube by hand. Stand the product upright and check the tightness of the joints by hand. Fit the bulb.
-
NOTE: Never fit bulbs of a higher wattage than those specified on the label (as these may cause overheating and damage the fitting)
-
Plugin, and operate the footswitch to turn your lamp on.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>