Shenzhen Century Xinyang Tech WD-R1206U 1200M Repeater Instructions

Shenzhen Century Xinyang Tech WD-R1206U 1200M Repeater Instructions

1 Plug in your wifi extender and wait for 30s

Until the 2 lights(2.4G and 5G) both on means able to start setting

111 If Abnormal, please reset:

Press and hold the “Reset/WPS’ or “Reset” key for 8 seconds and then release it. Wait until the 2.4G and SG lights are on to indicate a successful reset.

2 Connect your extender SSID

Both 2.4G and SG are available, choose 5G to setting

NOTE:

Please remember to tum off your mobile network data.
You have no access to Internet until you finish all setting steps, If your phone prompts that the network cannot be connected, click to continue

3 Open your browser webpage

(Google&Firefox Browser Recommended)

• NOTE:

Pis open the browser, entering 192.168.188.1 in the address bar and visit. 192.168.188.1
If access fails, please check if the correct SSID(wifl-5g-xxxx) is connected and the mobile data of the phone is turned off.

4 Enter the default password: admin

5 Scan and select your host router to connect

6 Enter the password of your host router

• NOTE:

Pis make sure of the right password
(special characters are notallowed,like-,”,blank,<,>)

Set your Extender SSID and password

*NOTE:

If you don’t want to modify, you can proceed lo the next step.

8 Check again and confinn the wireless information

‘NOTE:
After check,click ‘Start Connect” and wait 30-60s, the extender will connect to the router.

9 Walt for the repeater to connect to the router successfully.

10 The “Extender” Indicator lights on means successful connection.

11 Reselect and reconnect to your extender wifi

Re-select and reconnect to your extender wifi hospot
(The new will name defaults to the original wifi name plus pro-2 4G or 5G)

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.

§ 15.19 Labeling requirements.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.

§ 15.21 Information to user.

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
The antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co- located or operating in conjunction with any other antenna or transmitter.

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>