hama 00201646 12W USB-A Charger Instruction Manual
- June 6, 2024
- Hama
Table of Contents
hama 00201646 12W USB-A Charger Instruction
Operating instruction
Thank you for choosing this Hama product! Take your time and read the following instructions and information completely. Please keep these instructions in a safe place for future reference.
Explanation of warning symbols and notes
- Risk of electric shock This indicates arisk of electric shock from touching uninsulated product parts that may carry hazardous voltage.
- Warning This symbol is used to indicate safety instructions or to draw your attention to specific hazards and risks.
- Note This symbol is used to indicate additional information or important notes.
Package contents
- charger
- these operating instructions
Safety instructions
- Protect the product from dirt, moistureand overheating and use it in dry rooms only.
- Do not drop the product and do not expose it to any major shocks.
- Don’t operate the product outside the power limits specified in the technical data.
- Don’t modify the device in any way.Doing so voids the warranty.
- Do not continue to operate the product if it is visibly damaged.
- Use the product only for the intended purpose.
- As with all electrical products, this device should be kept out of the reach of children.
- Do not use the product in the immediate vicinity of heaters, other heat sources or in direct sunlight.
- Route all cables so thereisnorisk of tripping.
- Donot bend or crush the cable.
- Always pull directly on the plug when disconnecting the cable, never on the cable itself.
- Dispose of packaging material immediately in accordance with the locally applicable regulations.
- The product is intended only for use inside buildings.
- Only use the article under moderate climatic conditions.
- Don’t use the product in areas in which electronic products arenot permitted.
- Do not use the product in a damp environment and avoid splashing water.
Risk of electric shock
- Do not open the device or continue to operate it if it becomes damaged.
- Do not use the product if the AC adapter,the adapter cable or the mains cable are damaged.
- Don’t attempt to service or repair the product yourself. Leave any and all service work to qualified experts.
Operation
Note -mains voltage 100 -240 V The charger is suitable for mains voltages of 100 -240 Vand thereforecan be used worldwide. Please note that acountry- specificadapter may be necessary.
Warning -connecting devices
-
Before connecting device, check whether it can be adequately supplied with the charger’s current capacity.
-
Ensure that the power of the connected device does not exceed 20 W.
-
Note the instructions in your device’s operating manual.
Note -Power Delivery /QC3.0, 2.0 -
Plug &GO: no additional software is required, simply plug in and start: Thanks to Power Delivery /QC3.0, 2.0, the voltage and power are adjusted automatically.
-
Be aware that, for efficient and optimized charging, your terminal device must support the PD (Power Delivery) /QC3.0, 2.0 function.
-
If you have a large number of PD/QC-enabled devices with different firmware updates, it may be that the function is not fully supported.
Warning
- Only operate the product from a socket that has been approved for the device. The socket must be installed close to the product and must be easily accessible.
- Disconnect the product from the power supply using the On/Off switch –ifthis is not available, unplug the power cordfromthe socket.
- If using a multi-socket power strip, make sure that the total power consumption of all connected devices does not exceed the power strip’s maximum throughput rating.
- If you will not be using the product for a prolonged period, disconnect it from mains power. Unless different instructions have been expressly given in the operating instructions for the devices you arecharging, proceed as follows:
- Connect your device to a USB charging socket using a suitable USB cable.
- Connect the charger to a properly installed and easily accessible mains socket.
- The charging process is displayed on your device.
- Disconnect the device from the charger if you wish to interrupt the charging process or when the device is fully charged.
- Then disconnect the charger from the line connection.
- When charging the rechargeable batteries in the device, note the maximum charging times for the built-in batteries.
Care and maintenance
Only use soft, dry towels to clean the product.
Note Disconnect the device from the mains before cleaning and during prolonged periods of non-use.
Technical data
Speci fi cations according to Regulation (EU) 2019/1782
Brand name, commercial register number, address| Hama, HRA12159,
Dresdner Str. 9,
86653 Monheim, Germany
Model identifier| 00201649, 00201650
Input voltage| 100 – 240 V
Input AC frequency| 50 / 60Hz
Output voltage / output current / output power total| 5.0 V DC/ 3.0 A/ 15.0 W
9.0 V DC/ 2.22 A/ 20.0 W
12.0 V DC/1.67 A/ 20.0 W
Average efficiency during operation| 81.4 %
Efficiency at low load (10%)| 82.5 %
Power consumption at zero load| 0.10 W
Warranty disclaimer
Hama GmbH &CoKG assumes no liability and provides no warranty for damage resulting from improper installation/mounting, improper use of the product or from failure to observe the operating instructions and/or safety notes.