MOB ARMOR FLEX Magnetic Wireless Charger Instruction Manual

June 6, 2024
MOB ARMOR

Installation & Instructions

FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
FCC RF exposure statement:
The equipment complies with the FCC Radiation exposure limit set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body.

IMPORTANT!
DO NOT RETURN PRODUCT TO RETAILER!
IF YOU NEED WARRANTY SERVICE OR REPLACEMENT PARTS, PLEASE REACH OUT TO US DIRECTLY!
805-214-1815

Included Parts

Wireless Charging Puck
Phone Mounting Plate
USB-C Charging Cable

**WARNING:** Do not use magnetic mount near hard-drive-based devices such as an iPod Classic / Video. Use caution when using near pacemakers and other medical devices.
Check local and state vehicle laws regarding mobile device mounting and use. Do not mount any device on or near vehicle airbags.

**WARNING: This product can expose you to chemicals including DEHP, DINP, and BPA, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to[ www.p65wrnings.ca.gov**](http://www.p65wrnings.ca.gov)

Phone Mounting Plate Installation

  1. Wipe the phone or case surface with an included wipe before applying the template.

  2. Mag Flex Plate Installation tool has guidelines, ABCDE and 123.

  3. Point pull tab up and make sure Mob Armor Logo has positioned in the direction you want it positioned. Peel down the center tab to expose the adhesive center of the Mag Flex Plate. Use letter and number markers to find the center of your phone over your wireless charging location.
    Note: Mag Safe Cases and Phones will magnetically position the center. Non-Mag Safe devices will require an alignment template.

  4. Hold down the center of the Mag Flex Plate with one hand and peel down and back the sides of the position template. Double-check you are centered and aligned then remove the template. Press firmly with both hands the Mag Flexplate to your phone or case. Let’s Adhesive cure for 10 minutes before use.

Using With MobNetic Mounts

  1. Attach charger to mount before plugging in.

  2. Connect USB-C Cable to mount and adapter.

Compatible with MobNetic Maxx, MobNetic Pro 90, MobNetic Go, MobNetic Stik, MobNetic STXX

  1. Mount charger and MobNetic mount to the desired location.

WARNING:
It is possible for the Wireless Charger / Transmitter to interfere with some wireless systems within a car. Specifically, key fobs with immobilizers, keyless start systems, or tire pressure monitors. It is recommended to test the location of your transmitter before deciding on final placement. Most interference issues will be minimized by considering
the following

placement guidelines:
Install transmitter a minimum of 10 inches away from the ignition lock, key fob docking station, or any location where the key fob might be stored while driving. If the transmitter cannot be located a sufficient distance away as described above, please use the following suggestions whenever possible:

  • Insert the key fob into the docking slot whenever possible while operating the transmitter.
  • Connect the transmitter to a 12-volt accessory port that is powered only while the vehicle’s ignition is in the “ACC” or “ON” position.
  • Place phone on transmitter after a vehicle is started.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals