MTI Freedom Micro Ii Hs User Manual
- June 6, 2024
- MTI
Table of Contents
MTI-Freedom-Micro-Ii-Hs
COMPONENTS AND ACCESSORIES
BASEPLATE OPTIONS – ADHESIVE
ADHESIVE POSITION REMOVAL
BASEPLATE OPTIONS – SLOT & THROUGH-HOLE ADAPTERS
MOUNTING SLOT & THROUGH-HOLE ADAPTERS
SPEEDPLATE™ MERCHANDISING
REMOVING SPEEDPLATE™ FROM PUCK
REMOVING SPEEDPLATE™ FROM DEVICE
REMOVING PUCK FROM TETHER
Lift the puck out of the riser, and insert the crescent end of the Freedom Micro II tool into the opening below the charge port on the puck. Twist the Freedom Micro II tool counterclockwise to unlock the puck from the tether.
Once the puck is loose, rotate the puck 45 degrees counterclockwise in relation to the tether. Lift the puck off of the tether connection.
SPEEDBRACKET™ MERCHANDISING
Loosen the center screw on the universal bracket to loosen the bracket arms.
Extend the bracket arms as far as needed. The bracket arms move simultaneously in pairs (top & bottom, and left & right).
Place the phone into the universal bracket.
Adjust the universal bracket to fit the device snugly.
SPEEDBRACKET™ MERCHANDISING
Tighten the center screw on the SpeedBracket™ to secure the bracket arms in place around the device. After tightening the screw, wiggle the arms to ensure they have fully engaged the lock teeth, then re-check the screw for tightness. Place devise back onto the puck.
Rotate the device and bracket clockwise on the puck until it locks into place.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>