bloody M30 TWS True Wireless Earphones User Guide

: June 6, 2024
: bloody

Table of Contents

WHAT’S IN THE BOX
HOW TO WEAR
FIRST TIME USE
POWER ON & CONNECT
RECONNECT & DISCONNECT
CHARGING
CHARGE THE CHARGING CASE
CONTROL AT YOUR FINGERTIPS
LED INSTRUCTION
TECH SPEC
CLEANING AND MAINTENANCE
SAFETY RULES
WARNING STATEMENT
Read User Manual Online (PDF format)
Download This Manual (PDF format)

QUICK START GUIDE
M30ΤWS

WHAT’S IN THE BOX

HOW TO WEAR

FIRST TIME USE

Remove the insulation sticker from the earphones before the first time use. (Then put the earphones into the charging case and start charging both devices until fully charged before first-time use.)

POWER ON & CONNECT

Automatically enter pairing mode once take out the earphones. (L/R earphone can be used independently)
Choose “Bloody M30” to connect

RECONNECT & DISCONNECT

To reconnect, take out the earphones and it will automatically be connected. (Make sure the Bluetooth on your phone is turned on.)

CHARGING

Automatically charging once the earphones are inside the charging case. (The indicator will be solid red for 1s after putting the earphones back into the charging case; flashes blue once for each lOs when charging; no light when fully charged.)

CHARGE THE CHARGING CASE

CONTROL AT YOUR FINGERTIPS

(Long tap 2s to hang up a phone call or decline an incoming call.)

LED INSTRUCTION

(After putting the earphones back into the charging case, you can check the electricity with the indicator.)

| FLASHES RED AND BLUE — PAIRING
---|---
| NO LIGHT — WORKING
| FLASHES RED SLOWLY — LOW BATTERY

TECH SPEC

Speaker Size:	10 mm
Frequency Response:	20 Hz-20 kHz
Earphone Sensitivity:	105 dB @ -10 dBFS
Mic. Sensitivity:	-42 dB @1 kHz/Pa
Earphone Impedance:	32 ohm
Bluetooth Version:	v5.0
Operation Distance:	10 m
Earphone Battery Type:	Lithium Battery (40 mAh)
Charging Case Battery Type:	Lithium Battery (500 mAh)
Charging Power:	5V=500mA
Earphone Charging Time:	< 1.5H (Low Battery to Fully Charged)
Case Charging lime:	< 1.5H (Low Battery to Fully Charged)
Music Playtime with Single Charge:	=.4H (50% Volume Data).
Playtime from Charging Case:	=22H (50% Volume Data)
Weight:	37g

CLEANING AND MAINTENANCE

CLEANING YOUR EARPHONES AND GET THE BEST OUT OF THEM.

Keep the device dry and clean.
Remove the earphones sleeves and soak in water. Rinse well and then leave them to dry overnight.
Please use it until the sleeves are completely dry.
Clean the earphone and sleeves with gentle disinfectants.
Do not use alcohol-based disinfectants.
You can change the sleeves if necessary.

SAFETY RULES

To avoid hearing damage, do not use earphones at high volume for a long time.
Never disassemble or modify your earphones for any reason. Otherwise, it may cause the earphones to malfunction, which is not covered by the warranty.
Do not get the device wet with liquids, otherwise, it will cause serious damage to the device. Damage caused by water entering the device will not be covered by the manufacturer’s warranty.
Please do not place the product in an environment where the temperature is too low (above 45°C or below -10°C).
Do not place your device’s light close to eyes.
Not suitable for children under 3 years old.
Do not use the device during a thunderstorm.

WARNING STATEMENT

THE FOLLOWING ACTIONS MAY DAMAGE THE PRODUCT.

To disassemble, bump, crush, or throw into the fire is forbidden for lithium batteries.
Do not expose to strong sunlight.
The discard of the battery should obey the local law, if possible please recycle it. Do not dispose of it as household garbage, because it may cause an explosion.
Do not continue to use if severe swelling occurs.
Please try to avoid charging in an environment below 0°C.
The user is not allowed to remove or replace the batteries unless specified statement in the user manual.

FCC Regulatory Conformance : This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Conned the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radiortV technician for help

NOTE:
The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user’s authority to operate the equipment.
RF Exposure
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.

(Left ear) FCC ID: 2AXWI-M30
(Right ear) FCC ID: 2AXWI-M3001

The Bluetooth word mark and logos are registered trademarks owned by the Bluetooth SIG, Inc. and any use of such marks by Bloody is under license. Other trademarks and trade names are those of their respective owners.