Msa Innovation 10213012 Lunar Single Point Charger and Battery Instructions
- June 6, 2024
- Msa Innovation
Table of Contents
**Msa Innovation 10213012 Lunar Single Point Charger and Battery Instructions
**
Basic Operation
Activating an Alarm
Long press the Down or Enter button. The alarm sounds.
NOTE: If the button(s) is released before the three-second countdown ends, the alarm is not activated.
Cancelling an Alarm
Long press the Down or Enter button.
NOTE: If the button is released before the three-second countdown ends,
the alarm does not turn off.
Select YES in the the CANCEL ALARM dialog box. The alarm is cancelled.
Pairing with an External Device
Pairing can be established with external devices using the RFID tag in LUNAR.]
- Ensure the external device is in Data Link Mode, or Pairing Mode.
- Touch the RFID tag on LUNAR to the external device.
- Scroll through the TIC palettes until the Status screen is displayed.
Successful ConnectionPairing
Connection Established and then LostNo Pairing
Configuring and Maintaining
Connecting to FireGrid Configure
LUNAR can be configured to automatically connect with FireGrid Configure, making it discoverable for communication with FireGrid and connected devices.
- With LUNAR powered off, start a Quick Check.
- Open the Maintenance menu.
- Select DATA LINK. LUNAR attempts to connect with FireGrid Configure.
Connection in ProgressSuccessful Pairing
- Select DONE.
- In the DISCONNECT dialog box, select YES to disconnect or NO to remain paired.
Not Actively Transferring DataNo Pairing
Updating Firmware Software
If a firmware update is available, it can be installed from the Maintenance menu. This applies to LTE only.
- Open the Maintenance menu.
- Select UPDATE FIRMWARE.
- Select YES to confirm the update.
To cancel the update, select CANCEL.
NOTE: To update the firmware, the battery level must be at 50% or higher.
Charging the Battery
There are two ways to charge the LUNAR battery:
Using the Single Point Charger