WLN KD-C888 Pro Walkie-Talkie Set 2 Pcs User Manual

June 6, 2024
WLN

WLN KD-C888 Pro Walkie-Talkie Set 2 Pcs

OVERVIEW

  • UHF Super Receiving
  • Scanning
  • VOX
  • Alarm Function
  • Chinese/English Voice Prompt
  • Wide/Narrow Band Selection
  • High-Low Power Selection
  • Busy Channel Lockout
  • Low Battery Warning
  • 50 CTCSS/208 DCS

Charging the Battery

  • The battery is not charged in the factory, please charge the battery under the environmental temperature 5—40℃ before using.
  • After purchasing or long-term storage(more than two months), charging the battery for the first time can not reach its saturation capacity,repeat charge/discharge for twice or three times to make battery capacity achieve the best state.
  • Before charging, please power off the transceiver, using the transceiver during charging may affect correct charging.
  • If the battery has been charged fully, please do not charge it again,otherwise, the service life of the battery may be shorten or may be damaged.
  • If the service time is significantly reduced even after completely correct charging,the battery can not be used any more,please replace a new battery.

BASIC OPERATION

Power Switch(Volume Knob)
Turn the power switch to turn on/off the power. When power-on,turn the volume knob to adjust the volume.

Channel Selection
Turn the channel knob to adjust the channels.

PTT
Press this button whenever you wish to talk with the user of the other radio.

Monitoring
Press 【UP】 key to enter into the monitor mode, release it to exit.

Scanning
It is convenient for the user to search for calls from other channels.When“Side Key 2” in the software is programmed to the scanning function,press 【DOWN】 key to enter into the scanning mode,the transceiver will start to scan with the current channel;Operate it again to exit.

Emergency Alarm
When“Side Key 2” in the software is programmed to the alarm function, press 【DOWN】 key to alarm; Press PTT key to exit.

High-Low Power
The transceiver has a high-low power selection, it can be programmed.

Chinese/English Voice Prompt
The transceiver has a manual switching function between Chinese and English.Switch to Channel 16, turn off the transceiver,then press 【UP】 key and meanwhile turn on the transceiver to switch between the Chinese and English.

VOX
This function can be voice-activated so the user doesn’t have to press the PTT key. Switch to Channel 7,turn off the transceiver,then press the 【UP】 key and turn on the transceiver at the same time to switch between the ON and OFF of the VOX function. VOX gain inversion level refers to the voice sensitivity, it has level 1-9!

Busy Channel Lockout
The function can prevent interference from other transceivers using the same channel.

Battery Power Saving
If there is no signal or operation,the radio will reduce its power consumption.The battery power-saving function activates when the channel is unoccupied or has not been in operation.

Low Battery Warning
If the battery power falls to the predetermined value during transmission,the transceiver will give out a voice prompt, please charge in time.

Time Out Timer(TOT)
The purpose of the TOT is to prevent any single person from using a channel for an extended period of time.An alarm will sound if the transmission continues beyond the set time.The transceiver will stop transmission if this occurs.To stop the alarm,release the PTT key and the transceiver will return to standby.

CTCSS/DCS
The transceiver has 50 CTCSS and 208 DCS, also non-standard sub audio can be programmed!

Special Signaling
Special Signaling refers to the CDCSS on the channels is special processed codes.Only when the transceivers in the same company are programmed the same frequency point with the same CDCSS and meanwhile special signaling is programmed,then they can talk to each other.

Technical Parameters

SPECIFICATIONS

Frequency Range| 462.5500-462.7250MHz

467.5625-467.7125MHz

Supply Power| DC3.7V
Memory Channel| 22
Antenna Configuration| Internal Antenna

Work Mode

| Co/Differ-frequency

Simplex Communication

Ground Method| Cathode
Dimension| 12258.533.2mm
TRANSMITTER
Output Power| 2W/0.5W
Modulation Mode| FM(F3E)
Max.Frequency Deviation| ≤2.5KHz
Sparious Radiation| ≤7.5μW
Preemphasis Character| Per Octave 6dB
Emission Current| ≤1000mA
RECEIVER
Sensitivity| <0.16μV(12dB SINAD)
Audio Power| ≥300mW
Audio Distortion| <5%
Intermodulation

InterferenceResistance

| ≥60dB
Receiving Current| ≤300mA
Standby Current| ≤20mA

FCC Statement

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

  1.  This device may not cause harmful interference, and
  2.  This device must accept any interference received, including interference that may cause undesired operation.

ISED RSS Warning:
This device complies with Innovation, Science and Economic Development Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:

  1. this device may not cause interference, and
  2. this device must accept any interference, including interference that may cause undesired operation of the device.

RF Exposure Information (FCC SAR) :
RF Exposure Information (SAR) : The SAR limit of USA (FCC) is 1.6W/Kg averaged over one gram of tissue. Product Type: two way radio, model number: KD-C888Pro (FCC ID: 2AQX5KD-C888) has also been tested against this SAR limit. The device was test for typical body-worn operations and head face up operations keep the Tracker at least 25mm from the face.when worn on body must be correct back clip for this product,Use of non-approved accessories may result in exposure levels which exceed the uncontrolled environmental RF exposure limits.

RF Exposure Information (ISED SAR) :
The SAR limit of IC is 1.6W/Kg averaged over one gram of tissue. Product Type: two way radio, model number: KD-C888Pro (IC: 24229-KDC888) has also been tested against this SAR limit. The device was test for typical body-worn operations and head face up operations keep the Tracker at least 25mm from the face.when worn on body must be correct back clip for this product,Use of non- approved accessories may result in exposure levels which exceed the uncontrolled environmental RF exposure limits.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals