NOKIA TA-1392 T20 10.4 Inch 64GB/4GB WiFi Tablet User Guide
- June 6, 2024
- Nokia
Table of Contents
Get Started
Nokia xx
- Flash
- Back camera
- Loudspeaker
- Power/Lock key
- Volume keys
- Microphones
- Memory card slot
- Hall sensor
- Front camera
- Light sensor
- Loudspeaker
- USB connector
- Headset connector
Insert the memory card
- Open the memory card tray: push the tray opener pin in the tray hole and slide the tray out.
- Put the memory card in the memory card slot.
- Slide the tray back in.
Use only compatible memory cards approved for use with this device.
Incompatible cards may damage the card and the device and corrupt data stored
on the card.
Important: Do not remove the memory card when an app is using it. Doing
so may damage the memory card and the device and corrupt data stored on the
card.
Charge the battery and switch the tablet on
Plug a compatible charger into a wall outlet, and connect the cable to your
tablet. Your tablet supports the USB-C cable. You can also charge your tablet
from a computer with a USB cable, but it may take a longer time.
If the battery is completely discharged, it may take several minutes before
the charging indicator is displayed.
To switch your tablet on, press and hold the power key until the tablet
vibrates. The tablet guides you through the setup. For an online user guide
and troubleshooting help, go to www.nokia.com/mobile-
support.
Product and safety info
Important: For important info on the safe use of your device and battery, read the Product and safety info booklet before you take your device into use.
Your device has an internal, non-removable, rechargeable battery. Do not
attempt to remove the battery or back cover, as you may damage the device. To
replace the battery, take the device to the nearest authorized service
facility.
Charge your device with the AD-010U (US plug) / AD-010X (UK plug) / AD-010E
(EU plug) /AD-010A (Australia plug) / CH-21B (Brazil plug) / UT-580I-5200Z2Y
(India plug) / AD010C (China plug) / AD-010R (Argentina plug) chargers. HMD
Global may make additional battery or charger models available for this
device. Charging time can vary depending on device capability. Some of the
accessories mentioned in this user guide, such as charger, headset, or data
cable, may be sold separately.
The surface of the device is nickel-free.
Parts of the device are magnetic. Metallic materials may be attracted to the
device. Do not place credit cards or other magnetic stripe cards near the
device for extended periods of time, since the cards may be damaged.
Note: Pre-installed system software and apps use a significant part of
memory space. Keep a safe distance when using the flash. Do not use the flash
on people or animals at close range. Do not cover the flash while taking a
photo.
Note: The device is restricted to indoor use only when operating in the
5150 to 5350 MHz frequency range in the following countries:
| AT | BE | BG | HR | CY | CZ | DK |
|---|---|---|---|---|---|---|
| EE | Fl | FR | DE | EL | HU | IE |
| IT | LV | LT | LU | MT | NL | PL |
| PT | RO | SK | SI | ES | SE | UK(NI) |
Maximum transmit power
| Bluetooth® | 7.69 dBm |
|---|---|
| WLAN 5G | 17.48 dBm |
| WLAN 2.4G | 17.04 dBm |
Certification information (SAR)
This mobile device meets guidelines for exposure to radio waves as set forth by the Council of Europe (CE). Refer to the following.
European RF Exposure Information
Your mobile device is a radio transmitter and receiver. It is designed not to
exceed the limits for exposure to radio waves recommended by international
guidelines. These guidelines were developed by the independent scientific
organization ICNIRP and include safety margins designed to assure the
protection of all persons, regardless of age and health. The guidelines use a
unit of measurement known as the Specific Absorption Rate or SAR.
The SAR limit for mobile devices is 2.0 W/kg. As mobile devices offer a range
of functions, they can be used in many positions, such as on the body. In this
case, the highest tested SAR value is 0.31 W/kg at the separation distance of
0.5 cm from the body. For electronic safety, maintain the separation distance
with accessories containing no metal, that positions the handset a minimum of
the above distance. The use of other accessories may not ensure compliance
with RF exposure guidelines.
The tests are carried out in accordance with international guidelines for testing.
This mobile device meets guidelines for exposure to radio waves as set forth
by the Federal Communications Commission (FCC). Refer to the following.
FCC RF Exposure Information
Your device is a radio transmitter and receiver. It is designed and
manufactured not to exceed the emission limits for exposure to radiofrequency
(RF) energy set by the Federal Communications Commission of the U.S.
Government. The guidelines are based on standards that were developed by
independent scientific organizations through periodic and thorough evaluations
of scientific studies. The standards include a substantial safety margin
designed to assure the safety of all persons, regardless of age and health.
The exposure standard for wireless devices employs a unit of measurement known
as the Specific Absorption Rate or SAR. The SAR limit set by the FCC is 1.6
W/kg. The tests are performed in positions and locations (e.g. worn on the
body) as required by the FCC for each model. The highest SAR value for this
device model as reported to the FCC when
worn on the body in a holder or carry case, is 1.35 W/kg.
Body-worn Operation; This device was tested for typical body-worn operations
with the device kept 0 mm from the body. The use of belt clips, holsters, and
similar accessories should not contain metallic components in their assembly.
The use of accessories that do not satisfy these requirements may not comply
with FCC RF exposure requirements and should be avoided. The FCC has granted
an Equipment Authorization for this device model with all reported SAR levels
evaluated as in compliance with the FCC RF emission guidelines. SAR
information on this device model is on file with the FCC and can be found
under the FCC ID Search section of
www.fcc.gov/oet/ea/ after searching on FCC ID
2AJOTTA-1392.
Additional information on Specific Absorption Rates (SAR) can be found on the
FCC website at www.fcc.gov/general/radio-frequency-
safety-0.
To send data or messages, a good connection to the network is needed. Sending
may be delayed until such a connection is available. Follow the separation
distance instructions
until the sending is finished.
During general use, the SAR values are usually well below the values stated
above. The lower the power output, the lower the SAR value.
Device models may have different versions and more than one value. Component
and design changes may occur over time and some changes could affect SAR
values.
For more info, go to www.sar-tick.com.
Your mobile device is also designed to meet the United States Federal
Communications Commission (FCC) guidelines. FCC ratings for your device and
more information on SAR can be found at
http://transition.fcc.gov/oet/rfsafety/sar.html.
Information on IC SAR can be found at
http://www.ic.gc.ca.
The World Health Organization (WHO) has stated that current scientific
information does not indicate the need for any special precautions when using
mobile devices. If you are interested in reducing your exposure, they
recommend you limit your usage or use a hands-free kit to keep the device away
from your body. For more information and explanations and discussions on RF
exposure, go to the WHO website at www.who.int/peh-
emf/en.
Copyrights and other notices
EU Declaration of Conformity
Hereby, HMD Global Oy declares that this product is in compliance with the
essential requirements and other relevant provisions of Directive 2014/53/EU.
A copy of the EU Declaration of Conformity can be found at
https://www.nokia.com/en_int/s/declaration-of-conformity.
FCC Notice:
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. For more info, go
to www.fcc.gov/engineering-echnology/electromagneticcompatibility-division
/radio-frequency-safety/faq/rf-safety. Any changes or modifications not expressly approved by HMD Global
could void the user’s authority to operate this equipment. Note: This
equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
IC notice:
Innovation, Science and Economic Development Canada (ISED) CAN
ICES-3(B)/NMB-3(B)
Canadian Notice
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device must accept
any interference, including interference that may cause undesired operation of
the device.
Caution: Exposure to Radio Frequency Radiation
- To comply with the Canadian RF exposure compliance requirements, this device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter.
- To comply with RSS 102 RF exposure compliance requirements, a separation distance of at least 0 mm must be maintained between the antenna of this device and all persons.
Exposure of humans to RF fields (RSS-102)
The device employs low gain integral antennas that do not emit RF field in
excess of Health Canada limits for the general population; consult Safety Code
6, obtainable from
Health Canada’s Web site at http://www.hc-sc.gc.ca/
The radiated energy from the antennas connected to the wireless adapters
conforms to the ISED limit of the RF exposure requirement regarding ISED
RSS-102, Issue 5 clause 4. Operation in the band 5150-5250 MHz is only for
indoor use to reduce the potential for harmful interference to co-channel
mobile satellite systems.
For the frequency 5600-5650 MHz, no operation is permitted.
This device has an electronic label for certification information. To access
it, select Settings > System > Certification.
© 2021 HMD Global. HMD Global Oy is the exclusive licensee of the Nokia brand
for phones & tablets. Nokia is a registered trademark of Nokia Corporation.
OZO is a trademark of Nokia Technologies Oy.
The Bluetooth word mark and logos are owned by the Bluetooth SIG, Inc., and any use of such marks by HMD Global is under license.
References
- Welcome to the Health Canada Web site | Bienvenue au site Web de Santé Canada
- Language selection - Innovation, Science and Economic Development Canada Main Site / Sélection de la langue - Site principal d'Innovation, Sciences et Développement économique Canada
- Nokia Corporation
- Nokia Phones Support
- MWF - SAR Tick
- World Health Organization (WHO)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>