Shenzhen I Valux Technology W200 Apple Watch Wireless Charger User Manual
- June 6, 2024
- Shenzhen I Valux Technology
Table of Contents
Shenzhen I Valux Technology W200 Apple Watch Wireless Charger
Overview
This product is designed in a portable design, We wanted to make charging your Apple Watch utterly effortless. Simply hold the connector near the back of the watch, where magnets cause it to snap into place automatically. It charges all Apple Watch models and sizes.
Tech Specs:
- Input: DC 5V 1A
- Interface: MicroUSB
Operation
- Click the power button to tum on the power output, and the battery indicator light turns on, and the Apple watch can be attached to the magnetic charging position for charging. If the charger does not detect the Apple Watch within 38 seconds, it will automatically tum off.
- Double-click the power button to turn off the power output.
- After the Apple Watch is fully charged, you need to remove the watch and double-click the power button to turn out the power output.
Attention: The magnet attraction of the charging position 1s the role of
the Apple Watch in aligning the position when charging. It can’t be used as a
function to fix the watch. Please put it horizontally and do not move it when
charging. Do not hang
or sway, otherwise, the Apple watch may fall off and cause damage.
Caution:
- Please don’t dismount and remodel the product
- Pay attention to water-proof, moisture•proof.
- Please don’t charge in a hot environment.
FCC statement
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions: 1) this device may not cause harmful
interference, and 2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Radiation Exposure Statement
This device complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter. During the operation of
device a distance of 15 cm surrounding the device and 20 cm above the top
surface of the device must be respected.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>