Glen Dimplex AMERICAS 706955 Portable Electric Baseboard Heater User Guide
- June 5, 2024
- Glen Dimplex AMERICAS
Table of Contents
Glen Dimplex AMERICAS 706955 Portable Electric Baseboard Heater
IMPORTANT INSTRUCTIONS
When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following:
- Read all instructions before installing or using this heater.
- Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons.
- Always plug heaters directly into a wall outlet/receptacle. Never use an extension cord or relocatable power tap (outlet/power strip).
- Connect to properly grounded outlets only.
- Do not operate any heater with a damaged cord or plug or after the heater malfunctions, has been dropped or damaged in any manner. Discard heater or return to an authorized service facility for examination, and/or repair.
- Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Do not route cord under furniture or appliances. Arrange cord away from traffic area and where it will not be tripped over.
- Always unplug the heater when not in use.
- To disconnect the heater, turn the thermostat knob left, to the smallest dot, then remove the plug from the outlet.
- A heater has hot and arcing or sparking parts inside. Do not use it in areas where gasoline, paint, or flammable liquids are used or stored.
- This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes, and curtains away from heater.
- To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft surfaces, like a bed, where openings may become blocked.
- Do not insert or allow foreign objects to enter any ventilation or exhaust openings as this may cause an electric shock or fire, or damage the heater.
- This heater is not intended for use in bathrooms, laundry areas and similar indoor locations. Never locate heater where it may fall into a bathtub or other water container.
- Extreme caution is necessary when any heater is used by or near children or invalids and whenever the heater is left operating and unattended.
- Do not use outdoors.
SAVE THESE INSTRUCTIONS
Unanswered questions? Call our technical support team at 888.346.7539.
INSTALLATION INSTRUCTIONS
- CAUTION – High Temperature. Keep electrical cords, drapes, and other furnishings away from the heater.
- To reduce the risk of fire, do not store or use gasoline or other flammable vapors and liquids in the vicinity of the heater.
- Maintain 12 inches (30.5 cm) minimum clearance from all objects above and in front of the heater.
ASSEMBLY
Remove the heater and all items from the carton. Your heater is completely
assembled and has been designed to tilt slightly backward when its feet are
flat on the floor.
GROUNDING
Your portable heater is 120 volts, and it comes with a cord that has a
grounded, 3-prong plug. See Figure 1.
If you only have a 2-prong receptacle in your home, for safety reasons you
must use a grounding plug adapter. The green grounding lug extending from the
adapter must be connected to a permanent ground, such as a properly grounded
outlet box. See Figure 2.
The adapter isn’t necessary if you have a 3-slot grounded receptacle.
OPERATING INSTRUCTIONS
- Do not tamper with the high-temperature safety shutoff.
- Do not operate without the feet attached.
After placing your heater on the floor, plug it in, turn it to the highest
setting and allow it to run for at least 30 minutes. If your room doesn’t get
warmer, please contact us.
PLEASE NOTE: On initial start-up, some smoking may occur as the element
initially burns off the residue from manufacturing. It typically goes away
within several hours. If it persists, turn your heater off, unplug it and
contact customer service toll-free: 888.346.7539
How to operate your heater
The room temperature is controlled by the thermostat on the heater. Simply
plug it in and follow the steps below to adjust the temperature to your
comfort level.
- Turn the thermostat knob all the way to the right.
- When the room reaches your comfort level, turn the knob to the left, just until it clicks. The heater will automatically keep the room temperature around this setting.
- To reduce the room temperature, turn the knob to the left. To increase the room temperature, turn the knob to the right.
The larger dots indicate a higher temperature setting. The smallest dot is an OFF position.
High-temperature and safety tip-over shutoffs
Your portable electric baseboard comes with a built-in high-temperature safety
shutoff that stops electricity flowing to the heater if it gets too hot
inside. This automatically resets after cooling.
Your heater also includes a safety tip-over switch that disconnects power if
it falls over, and resets as soon as the heater is standing up again.
MAINTAINING YOUR HEATER
Clean heater at least every 6 months or as required.
- It is important that you verify the heater is unplugged and the element is cool.
- Wipe cover with a damp cloth and dry.
- Use the hose on your vacuum to clean the heater. Do not touch the element.
- Plugin the heater when complete.
Any service other than cleaning should be performed by an authorized service representative.
TROUBLESHOOTING
TROUBLESHOOTING
Symptom| Problem| Solution
The heater is making noise.| 1. Heater makes creaking or
popping noises.
| 1. The heating element expands slightly when turned on. This
is normal.
The heater smells when first plugged in or after not being used.| 1. Odor from element
manufacturing process.
2. Dust or lint inside the heater.
| 1. On initial start-up, the heater may cause an odor due to the manufacturing process. It typically goes away within several hours.
2. Clean heater (see “MAINTAINING YOUR HEATER” above for instructions).
Heats briefly then stops.| 1. High-temperature safety shutoff has tripped.
2. Safety tip-over switch has tripped.
| 1. Remove all obstructions. Do not block heater. Maintain 12 inches (30.5 cm) above and front. Keep heater free of lint and dust. The high-temperature safety shutoff resets after cooling.
2. Stand the heater up so it’s in an upright position. The tip-over
switch resets immediately.
The heater doesn’t turn off.| 1. Incorrect heater wattage for room size.
2. Thermostat is defective.
| 1. If additional heat is needed consult an electrician as circuit(s)
maybe limited.
2. Replace the thermostat.
WARRANTY
For more effective and safer operation and to prolong the life of the heater,
read the Owner’s Guide and follow the instructions. Failure to properly
maintain the heater will void any warranty and may cause the heater to
function improperly.
LIMITED TWO YEAR WARRANTY: The manufacturer will repair or replace any
portable baseboard heater found to be defective within two years after the
date of purchase.
These warranties do not apply:
- Damage occurs to the product through improper installation or incorrect supply voltage;
- Damage occurs to the product through improper maintenance, misuse, abuse, accident, or alteration;
- The use of unauthorized accessories or unauthorized components constitutes an alteration and voids all warranties. Refer to the Manufacturer’s website or call customer service at 888.346.7539 for list of authorized accessories and components.
- A manufacturer’s warranty is limited to repair or replacement.
- In the event Manufacturer elects to replace any part of your product, the replacement parts are subject to the same warranties as the product. The installation of replacement parts does not modify or extend the underlying warranties. Replacement or repair of any product or part does not create any new warranties.
If you believe your product is defective, please contact the manufacturer during the warranty period, for instructions on how to have the repair or replacement process.
Parts and Service
Visit gdaheat.com/parts for information on where to obtain parts and services.
To register your product, visit gdaheat.com/register
Reduce-Reuse-Recycle
This product is made primarily of recyclable materials. You can reduce your
carbon footprint by recycling this product at the end of its useful life.
Contact your local recycling support center for further recycling
instructions.
More frequently asked questions on our website here: gdaheat.com/FAQ ©2020 Glen Dimplex Americas Printed in the USA
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>