ORE-TEK OERSPT1 Tire Pressure Sensor Tool User Manual
- June 5, 2024
- ORE-TEK
Table of Contents
ORE-TEK OERSPT1 Tire Pressure Sensor Tool
Setting
- Set up pressure/ Temp. / ID/ Region
- Be sure to choose the correct REGION before programming
Tool Info.
This Step is not necessary unless the supplier need your help to inform the tool information for a manufacturer to double-check the tool status or fixing (one example as righ column; please note those are not the latest version, only for diagram reference.)
Check IM sensor
This step is also not necessary.
It’s the little helper while you are unsure what iM item number you just
programmed, that you can run as following:
Home/ Check iM Sensor/ Scan sensor/ Enter to scan, then you will see the iM
item and it’s ID numbers (one example as right column)
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one of the following measures: . Reorient or
relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. (Example – use only shielded interface cables when connecting to computer or peripheral devices).