BGS technic 965 Torque Wrench User Manual
- June 5, 2024
- BGS technic
Table of Contents
BGS technic 965 Torque Wrench
Torque Wrench
SPECIFICATION
| 967| 966| 965| 971| 968| 969| 970|
990
---|---|---|---|---|---|---|---|---
Range Nm| 6-30| 20-110| 42-210| 70-350| 100-500| 140-700| 140-980| 140-980
Drive| 1/4“| 3/8“| 1/2″| 1/2″| 3/4“| 3/4″| 1“| 3/4“
Division Nm| 0.2| 0.5| 1.0| 2.5| 2.5| 2.5| 7.0| 14
HOW TO USE
-
Balancing wrench in hand with graduations visible with the marked arrow elementary Scale-up then unlock knurled handle by pulling sleeve.
-
Set the amount of torque required by turning knurled handle to read the exact amount on case graduations.
-
Turn the knurled handle until the zero graduation on the bevel edge of the knurled handle is lined up with the vertical mark on the case and is even with the 50 ft.Lbs graduation.
-
Turn the knurled handle clockwise until 6 ft. Lbs graduation on the level edge of the handle is in line with the vertical line on the case.
-
Lock handle securely by pushing sleeve, and now wrench is set at 56 ft, Lbs which is ready to use.
-
install the proper socket or attachment to the square drive and apply it to the nut or ball and pull the handle until you feel and/or hear the wrench click. Release pull and
wrench automatically resets for the next operation. -
Do not continue to pull after wrench releases. Use special care at low torque settings that will pull stop when the wrench clicks.
CAUTION
- If the wrench has not been used or has been in storage for some time, operate it several times at a low torque setting which permits special internal lubricant to re-coat internaI working parts.
- When the wrench is not in use, keep doing adjustments at lowest torque setting.
- Do not turn the handle below the lowest torque setting.
- Do not continue pulling on the wrench after pre-set torque has been reached and the wrench has been released. Pressure must be taken off the handle and the wrench allowed to automatically reset itself, continuing to apply pressure after the wrench has been released, will result in damage to the part being torque by applying more than the specified amount of torque.
- The tool is rugged and designed for shop use, but is also a precision measuring instrument and should be treated as such.
- Clean wrench by wiping .Do not immerse in any type of cleaner which may affect special high-pressure lube with which the wrench is packed at the factory.
- This torque wrench was calibrated and tested before leaving the factory and is accurate to ±3%.
- The key is only suitable for a permissible torque, which can be found in the table above.
- This is a precision measuring instrument.
- Calibration and servicing must be done regularly and is the owner’s responsibility.