ZKTeco FR1500S Fingerprint Reader Installation Guide

Installation Guide
FR1500S
Version: 1.0

Due to regular upgrades of systems and products, ZKTeco could not guarantee exact consistency between the actual product and the written information in this manual.

Installation

Dimensions(mm)

Note: Not all the devices have a fingerprint cover. The real product prevails.
Procedure to be followed before installation

STEP 2 Take out the front panel as shown below

Method 1: Mounting on the standard Single gang junction box
Lay the cables from the desired hole in the Single gang junction box and fix the machine part to the box part.
The Single gang junction box’s size recommendations: Location column: 83.3mm Inside of the box Depth: Minimum 36mm Outside the box size: maximum length 120mm, maximum width 76mm

Method 2: Mounting inside the wall
STEP 1
Place the mounting sticker to the place where device needs to be installed

STEP 2
Drill fixing holes and dig mounting groove deep of 36mm

STEP 3
If cables need to be laid from behind then it must be done before installing

STEP 4 Install the device with the screws

STEP 5
After installing the backplate attach the machine part in the same reverse manner as shown in the previous page

References

• ZKTeco | Biometrics and Computer Vision

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>