starlab S7166-0010 ErgoOne Fast Pipette Controller User Manual
- June 5, 2024
- starlab
Table of Contents
starlab S7166-0010 ErgoOne Fast Pipette Controller
Removing the discharge protector
Prior to first usage please proceed as follows:
-
Slide the battery compartment lid open.
-
Remove the battery and discharge protection.
-
Install the battery and close the battery compartment lid.
Battery status display
Ready for operation:
-
Solid green light:
The rechargeable battery is fully charged.
-
Solid yellow light:
The rechargeable battery is half-charged.
-
Solid red light:
The rechargeable battery is almost empty.
Charge battery:
-
Flashing red light:
The rechargeable battery is <5% charged.
-
Flashing yellow light:
The rechargeable battery is 5-60% charged.
-
Flashing green light:
The rechargeable battery is 60-99% charged.
Empty battery
- Flashing red light:
The rechargeable battery needs to be charged.
Speed control
The liquid aspiration speed is regulated continuously by controlling the pressure on the control buttons, i.e. how far in the button is pressed.
Slow aspiration
To slowly aspirate or dispense liquid, press the corresponding control button
lightly.
Quickly aspirating
To quickly aspirate or dispense liquid, press the corresponding control button
firmly.
Passonate for science.
Documents / Resources
|
starlab S7166-0010 ErgoOne Fast Pipette
Controller
[pdf] User Manual
S7166-0010, ErgoOne Fast Pipette Controller
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>