manhattan 102407 Phone Sanitizer with Qi Wireless Charger Instructions
- June 5, 2024
- Manhattan
Table of Contents
manhattan 102407 Phone Sanitizer with Qi Wireless Charger
Mobile phone wireless charging Status indicator
- The white light is always on when the battery is on standby
- When wireless charging, the white indicator light breathes.
- Full of white lights,
- Abnormal white light flash
- After charging, remove the smart phone from the wireless charging disinfection box.
Instructions for disinfection:
- short press the disinfection switch button to open the disinfection mode, you will hear a “beep”.
- Press the button briefly and when the disinfection box is closed, the green light will be on, indicating that the disinfection mode is in progress.(Staphylococcus aureus and E. coli can be killed by 99.9%).
- During disinfection, when the cover is opened, in order to prevent minor burns to the eyes, the disinfection lamp and violet light lamp will be put out.When the cover is closed, the disinfecting procedure (magnetron switch control) will resume.
- When the disinfection time reaches 5 minutes, you will hear three beeps and the indicator light flashes for three times and then goes off, indicating that the disinfection is completed.
- Press the button for 3 seconds, and you will hear three beeps. The indicator light flashes for three times and then goes out, indicating that disinfection is turned off.
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation. 2. Changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.