Hongdi Toys Factory G03066R Remote Control Car Instructions
- June 5, 2024
- Hongdi Toys Factory
Table of Contents
Hongdi Toys Factory G03066R Remote Control
Car Instructions
Driving Tips & Transmitter
Battery Installation
- Open the vehicle’s battery cover. install the battery pack and connect it to the vehicle.
- Open the transmitter’s battery cover, and install 2X1.5AA” batteries with the correct polarity as shown inside the battery compartment. (NOT INCLUDED)
- Replace the battery cover and tighten the screw with a screwdriver.
Operation Manual of Remote Control
Bind the transmitter to the receiver. The indicator lights on after the body power is connected. The indicator flashes when the remote controller is connected with the power supply and lights go out after the frequency alignment is completed. The indicator lights on when operating. Switch the power OFF on the transmitter and vehicle after use, preventing power from consumption.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 1 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation, This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications, However,_, there is no guarantee that interference will not occur in a particular installation, If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected,
- Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation,
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>