POOL BLASTER 8423 Hydro Broom 100 Pool Cleaner User Manual

POOL BLASTER 8423 Hydro Broom 100 Pool Cleaner

IMPORTANT SAFETY INSTRUCTIONS

1.  Read carefully and understand all safety warnings before using this appliance.
2. Do not attempt to operate if the cleaner or USB charging cord appears to be damaged in any way.
3. All cautions and warnings on the equipment should be noted.
4. Never allow children to operate this product. This is NOT a toy. Children should be supervised to ensure they do not play with this product.
5.  Keep the cleaner and its accessories out of reach of children.
6. This cleaner is not intended for use by persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.
7. Charge indoor only. Do not use or store the USB charging cord outdoors. Charge your cleaner in a clean, dry place and only with the USB charging cord provided. Do not use a USB charging cord supplied with any other appliance.
8. The warnings cautions and instructions discussed in this instruction manual cannot cover all possible conditions or situations that could occur. It must be understood, that the operator should always exercise intensive caution and common sense when utilizing the cleaner.
9. Risk of electric shock. Do not expose to liquid, vapor, or rain. Store cleaner in a clean dry place. Do not store in direct sunlight or be exposed to extreme temperatures.
10.  Do not plug or unplug the USB charging cord into a power source or the appliance with wet hands.
11. Do not operate this cleaner in the presence of flammable or combustible liquids.
12.  Never service the cleaner while the unit is on or connected to the USB charging cord.
13.  Installation work and electrical wiring must be done by a qualified person(s) in accordance with all applicable codes and standards, including fire-rated construction.
14. Use only the USB charging cord supplied with the cleaner. Never carry the USB charging cord by its cord or disconnect it from an outlet by pulling on the cord.
15. For pluggable equipment, the socket outlet shall be installed near the equipment and shall be easily accessible.
16.  Keep proper footing and balance at all times when using the cleaner. Do not overreach.
17. Please disconnect this equipment from the AC outlet before cleaning. Don’t use liquid or sprayed detergent for cleaning. Use a moisture sheet or cloth for cleaning.
18. This cleaner contains rechargeable batteries. Do not incinerate the battery as it will explode at high temperatures. Always dispose of batteries in accordance with local law.
19. Leaks from a battery may occur under extreme conditions. If battery liquid gets on the skin, wash immediately with water. If it gets in your eyes, immediately flush your eyes with a mild solution of baking soda and water, and seek medical attention.
20. Keep hair, loose-fitting clothing, and all body parts away from openings and moving parts of this cleaner.
21. Use this product only for its intended purpose as described in this manual. Use only Water Tech accessories and filters.
22. This product is not intended for commercial use.
23.  If the equipment is not in use for a long time, disconnect the equipment from the mains to avoid being damaged by transient over-voltage.
24.  Never leave your cleaner in water when it is “OFF” or when it has run out of power.
25.  Do not use your cleaner for pool openings; the cleaner is designed for routine maintenance of your pool or spa.
26. The cleaner is designed for underwater use in swimming pools or spas only. It is not an all-purpose vacuum cleaner.
27.  Submerge the cleaner in water immediately after turning the unit “ON” to prevent damage to the seal on the motor shaft. Failure to do so will shorten the life of the water seal and/or void the warranty.
28.  Avoid picking up sharp objects as they may damage the filter. Keep all openings on the cleaner free of debris which may reduce water flow.
29. Do not place the cleaner or the USB charging cord on or near hot surfaces.
30.  For best results use the USB charging cord in locations where temperatures are between 50˚ F / 10˚C and 100˚ F / 37.7˚ C.
31. For connection to a supply not in the U.S.A., use an attachment plug adapter of the proper configuration for the power outlet.

SAFETY AND USAGE SYMBOLS

The following symbols and meanings are intended to explain the levels of risk associated with this product:

SYMBOL       SIGNAL                     MEANING

           WARNING!| Indicates a hazardous situation, which, if not avoided, could result in death or serious injury.
           DANGER!| Indicates a hazardous situation, which, if not avoided, could result in death or serious injury.
CAUTION!| Indicates a hazardous situation, that, if not avoided, may result in minor or moderate injury.
The following symbols and meanings are intended help you operate the product better and safer. Please study them and learn their meanings.

SYMBOL                         NAME EXPLANATION

                     SAFETY ALERT| Indicates a potential personal injury hazard. Basic precautions should always be followed when seeing this symbol.
**| DO NOT GET WET| Indicates by NO MEANS water should touch the indicated part with this symbol. If not avoided, may result in minor or moderate injury.
   4| CHARGE FOR 4 FULL HOURS| **

Indicates to charge product for the 4 complete hours.

**| BATTERY RECYCLE| **

Recycle batteries in accordance with local law.

**| DISPOSAL| **

Dispose of any unwanted product in accordance with local law.

**| CE| European Conformity.
| RoHS**| Restriction of Hazardous Substances Compliance.

Product Breakdown 

Charging the battery:

• It requires a USB charging adapter (not included) with the following specifications:
• Input    100-240V AC, 50-60Hz
• Output.  5.0V DC and 1.0A
• Battery Tech Data   3.7V, 2200mAH, 8.14Wh Li-Ion
• Charge Temperature.   Maximum 100°F, (37.7°C) Minimum 50°F, (10°C)

Operation

• Water temperature range     Maximum 96°F, (35°C) Minimum 40°F, (5°C)
• Operation Depth.              Maximum 12 ft. (3.5 m), Minimum 10 in. (0.25 m)
• Make sure the charging receptacle on the product is dry before any charging.
• A full charge takes up to 4 hours. For EU Market, a CE-certificated USB charging adapter shall be used. For US and Canadian markets, a Class 2 type adapter is certificated by North American standards.

FCC Compliance

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2.   this device must accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation, If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try and correct the interference by one or more of the following measures:

•  Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different than that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

NOTE: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

LIMITED WARRANTY

Water Tech Corp (“WT”) warrants this product, including supplied accessories against defects in material or workmanship for the time periods as set forth below. Pursuant to this Limited Warranty WT will, at its option (i) repair the product to the original specifications or (ii) replace the product with a new or refurbished product. In the event of a defect, these are your exclusive remedies. For purposes of this Limited Warranty, “refurbished,” means a product or part that has been returned to its original specifications.All Pool Blaster Battery Powered Pool & Spa Vacuums. For a period of one (1) year from the original date of purchase of the product, WT will, at its option, repair or replace with a new or refurbished product or parts, any product or parts determined to be defective. Accessories. Included accessories are covered by this Limited Warranty for a period of (90) days from the original date of purchase of the product. Instructions. Please retain the original box and internal packaging materials. To obtain warranty service, you must comply with the following requisite instructions:

1.  Visit Water Tech Corp’s Customer Support Department via the web at www.wtrma.com. You will be guided through the correct process on how to obtain the required RMA# (Return Merchandise Authorization Number.) All customers must obtain an RMA number before any product will be accepted for warranty service. If you need additional assistance please contact us by telephone: at (732-967-9888) or email: customerservice@watertechcorp.com.
2.  Package the unit and the WT battery charger only ( if the unit requires a WT charger ) properly and securely in the original box.
3. Attach your RMA number and the Bar-Code you received from the website to the outside of the package. If you could not print the RMA number and bar-code from the website you must write your RMA number in thick black indelible marker on two sides of the box.
4.  Send the package by USPS or express courier of choice to Water Tech Corp, 10 Alvin Court, East Brunswick, New Jersey 08816; (WT suggests you insure the contents of your package.) WT is not responsible for lost, stolen or damaged property in transit to WT.

Repair/Replacement Warranty. This Limited Warranty shall apply to any repair, replacement part, or replacement product for the remainder of the original Limited Warranty period or for ninety (90) days, whichever is longer. Any parts or products replaced shall become the property of WT.
This Limited Warranty covers only product issues caused by defects in material or workmanship during ordinary consumer use; it does not cover product issues caused by any other reasons, including but not limited to product issues caused by commercial use, acts of God, misuse, abuse, limitations in technology, or modification of or to any part of the WT product. This Limited Warranty does not cover WT products sold AS IS or WITH ALL FAULTS or consumables (such as batteries). This Limited Warranty is invalid if the factory-applied serial number has been altered or removed from the product. This Limited Warranty is valid only in the United States and Canada.
EXPRESS LIMITATION: THIS LIMITED WARRANTY ONLY APPLIES IF THE PRODUCT WAS PURCHASED FROM AN AUTHORIZED WATER TECH DEALER. THIS WARRANTY IS NOT TRANSFERABLE
LIMITATION ON DAMAGES. WT WILL NOT BE LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES FOR BREACH OF EXPRESS OR IMPLIED WARRANTY ON THIS PRODUCT.

DURATION OF IMPLIED WARRANTIES. EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW, ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE ON THIS PRODUCT IS LIMITED IN THE DURATION OF THIS WARRANTY. Some states do not allow the exclusion or limitation of incidental or consequential damages or allow limitations or how long an implied warranty lasts, so the above limitations or exclusions may not apply to you. This Limited Warranty gives you specific legal rights and you may have other rights, which vary from state to state.

Charging Your Cleaner

Initial Charge 4 HoursRecharging (After Complete Discharge) 4 Hours Maximum charging time should not exceed 24 Hours

Closing the Battery Chamber

Cover charging jack with rubber plug

Inserting the Filter Bag

Cleaning the Filter Bag

• You should remove and clean the Filter Bag following each use (Figure F.1).
•  Don’t scrub the bag against itself while rinsing it.

Long Term Storage

• Always clean the Head Cover and Filter Bag before storing.
•  Always store and charge your cleaner in a cool, dry indoor shelter.
•  Recharge the cleaner indoors for 4 hours after each month of inactivity.
• Never leave your USB charging cord connected to the cleaner for more than 24 hours.

Attaching the Pool Pole Turning the unit ON / OFF
Maintenance

END OF LIFE BATTERY DISPOSAL

The maintenance-free, Lithium-Ion battery in your Pool Blaster must be properly disposed of in accordance to State and local law. To confirm if recycling is required; contact your local authority for information.
WARNING!

Never attempt to disassemble a battery pack.

1.  Remove all personal items such as rings, bracelets, necklaces, and watches when unwiring a pack from the vacuum unit.
2.  A battery can produce a short circuit current high enough to weld a ring (or like item) to metal causing a severe burn.
3. Wear complete eye protection, gloves, and protective clothing when removing the battery pack.
4.  Take care not to touch wires together or allow them to contact any metal items, which would cause sparking and/or short circuit the battery.
5. Never smoke or allow a spark or flame in the vicinity of the battery or the cleaner. Batteries can generate gases that could possibly ignite.
6.  Do not expose to fire or intense heat as this may result in an explosion.

CAUTION!

If a battery leak develops, avoid contact with the leaking acid and place the damaged battery in a plastic bag.

7. If acid comes in contact with skin and clothing, wash immediately with plenty of soap and water.
8. If acid comes in contact with the eyes, immediately flood the eye with running cool water for at least 15 minutes. Get medical attention immediately.

How to remove the battery

Recommended tools (not included): Philips screwdriver, wire-cutters, electrical tape.

1. Detach the battery chamber from the powerhead.
2.  Using the Philips screwdriver, unfasten the 2 screws on top of the motor box.
3. Pull the battery out shown in image three.
4. Using the wire cutters, cut the wires as shown in image four. Do not cut both wires at the same time.
5.  Wrap the wires with electrical tape. Dispose of according to local law.

Register at www.watertechcorp.com/register

10 Alvin Ct., Suite 111
East Brunswick, NJ 08816 – USA
Tel: 732-967-9888 US, Canada & International Fax: 732-967-0070 US & International
www.WaterTechCorp.com

References

• Home - Water Tech New
• Watertech RMA Portal

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>