CYRUS CM17XA Mobile Phone User Guide
- June 5, 2024
- CYRUS
Table of Contents
CM17 XA
|
---|---
User Manual
For downloading the complete user manual, please visit our website: | www .cyrus-technology.de/en/devices/mobile-phones/cm-17xa/
Quick Power On
1. Circumrotate the screw (Please unscrew both screws counterclockwise)| 2.
Open the battery cover (After loosening the screws, please remove the battery
cover)| 3. Insert the SIM card(s) (Please insert your SIM card(s) as shown in
the picture)
---|---|---
| |
4. Insert Micro-SD-card (Please insert your SD-card as shown in the picture)|
5. Close the battery cover (Please turn both screws clockwise)| 6. Please
charge for 12 hours before first usage
| |
Keypad Description
1. SOS Button
2. PTT Button
3. Programmable Button 1
4. Dialing key
5. Headphones| 6. Volume +/-
7. Programmable Button 2
8. Power ON/OFF
9. USB
---|---
Simplified declaration of conformity (Valid for the EU)
The simplified EU declaration of conformity according to article 10, paragraph
9, reads as follows: Cyrus Technology GmbH hereby declares, that the radio
system type Cyrus CM17 XA complies with the regulations of the EU directives
2014/53/EU.
The full text of the EU declaration of conformity is available at the following Internet address: www.cyrus-technology.com
FCC RF Exposure Information and Statement
This device meets the government’s requirements for exposure to radio waves.
The guidelines are based on standards that were developed by independent
scientific organizations through periodic and thorough evaluation of
scientific studies. The standards include a substantial safety margin designed
to assure the safety of all persons regardless of age or health. The SAR limit
of USA (FCC) is 1.6 W/kg averaged. Device types: Rugged Phone (FCC ID:
2AI3KCM17XA) has also been tested against this SAR limit. SAR information on
this and other pad can be viewed online at http://www.fcc.gov/oet/ea/fccid/.
Please use the device FCC ID number for search. This device was tested for
typical body-worn operations with the back of the handset kept 10mm from the
body and 10 mm to mouth. To maintain compliance with FCC RF exposure
requirements, use accessories that maintain a 10mm separation distance between
the user’s body and the back of the handset. The use of belt clips, holsters
and similar accessories should not contain metallic components in its
assembly. The use of accessories that do not satisfy these requirements may
not comply with FCC RF exposure requirements, and should be avoided.
FCC Warning
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
NOTE 2 : Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.