BIXOLON XL5-40CT Series Label Printer Instruction Manual
- June 5, 2024
- BIXOLON
Table of Contents
BIXOLON XL5-40CT Series Label Printer Instruction Manual
Instructions
-
After the Printer Power Switch Off at the rear of the Printer, Unplug the Power Connector from the Power Jack.
-
Open the Printer, and while pressing the yellow circle on the Cover Cutter, Disassemble the Paper Support upwards (yellow arrow). Remove the Cover Cutter by pressing the Hook (in Red circle & arrow) downward.
-
Remove one screw (in Red circle) using a screwdriver. Disassemble each part in the order of Cover Front & Cover Taken with slightly raised upwards.
When disassembling the Cover Taken, be careful not to disconnect the wire.
-
Remove two screw (in Red circle) using a screwdriver. Disassemble the Auto Cutter forward while slightly raising it up. Disassemble the Auto Cutter Wire from Cover Taken Connector and Reassemble the new Auto Cutter. #1 When reassembling, hang the Auto Cutter Wire on the Hook (red square). EF When reassembling, arrange the Ground Wire down. Be careful to avoid tangling with other wires when shaping.
-
After twisting the Auto Cutter Wire (In Red square), put it in the Inner space (red circle).
-
Reassemble the Cover Taken Hook(Red Circle parts) into the Printer(Yellow Squares). 3(4 Be careful that the Wire does not get stuck.
-
Reassemble the Cover Front Hook (Red Circle parts) into the Printer (Yellow Squares). X Be careful that the Wire does not get stuck.
-
While pressing Cover Taken & Cover Front down, reassemble (Red circle). Be careful that the Wire does not get stuck.
-
Reassemble the Paper Support that was removed in step 2. Reassemble the hook on the red circle of the Cover Cutter into the red square hole.
See the Manual for how to supply paper.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>