BIXOLON SPP-R200III Mobile Printer Instruction Manual

BIXOLON SPP-R200III Mobile Printer Instruction Manual

Manual Information

This Bluetooth Connection Manual provides information on the connection of Bluetooth-enabled iOS devices with the printer (SPP-R200III).

We at BIXOLON maintain ongoing efforts to enhance and upgrade the functions and quality of all our products. In following, product specifications and/or user manual content may be changed without prior notice.

Precautions

1. To connect the printer with another device via Bluetooth, the devices must be within 10m of one another. The connection is broken if the distance between devices exceeds 10m.
2. The maximum separating distance may be shortened if transmission obstacles, such as cement walls, are present.
3. If a device (such as a microwave oven, wireless LAN, etc.) that uses the same frequency is present, transmission may be interrupted. Separate the printer and Bluetooth-enabled device from such interrupting devices by a distance of at least 5m.

i0S MFi mode change

You can switch over to MFi mode which allows you to have Bluetooth connection with iOS devices. (Note: Make sure that MFi mode must be on.)

Set-up by printer button

1. Turn on the printer power.
2. Push the power button and feed button for 2 seconds while paper cover is opened.
3. After beep sound, close the cover.
4.  Reboot the printer after checking below message.
   • i0S mode enable!!
   • Please Reboot Printer!!
5. Repeat above procedure to make MFi mode disable.

2i0S mode check

Implement Self Test

• If firmware version is Vxx.xx STOBa, iOS mode will be disable.
• If firmware version is Vxx.xx STOBI, iOS mode will be enable.

Bluetooth Connection Instructions

1i0S mode enable

1. Select the icon.
   

2. Select “Bluetooth”.
   

3. Select the printer to connect.
   

4. Enter PIN. (default : 0000)
   

5. Select “Pair”
   

6. Bluetooth communication is available.
   

Android mode(iOS mode disable)

1. Select the icon.
   

2. Select “Bluetooth”.
   

3. Select the printer to connect.
   

4. Enter PIN. (default: 0000)
   

5. Select “OK”.
   

6. Bluetooth communication is available.
   

NFC Auto pairing

Referring to 4-2 Android mode, paring process will be simplified by means of using NFC Auto paring function. (Only, the device should support NFC Read/Write function.)

1. Tap your host device to NFC tag
   

2. Enter PIN. (default: 0000) on a printer. (Following process is the same as 5), 6) in 4-2
   

Troubleshooting

Please follow the guide below if Bluetooth is not searched on iOS device.

1. Perform self test to check the printer is set as iOS mode.
2. Check whether printer is connected to other iOS device. Printer is not able to be found on your iOS device if it is connected to other iOS device. If STATUS LED blinks when you press Feed button, it means that printer is connected to other iOS device. You need to disconnect the connection to other iOS device, or turn on the printer again while the paper cover is opened.

Printer is automatically connected to last iOS device which was connected in iOS mode. But it does not make a connection to any device, if user turns it on while the paper cover of it is opened.

Refer to this, if you see the pop-up message as below.

“Failed to connect to SPP-R200III”.

Failed to connect to SPP-R200 The “Failed to connect” message might appear on a screen, since NFC Auto pairing merely supports Bluetooth paring and does not allow device to device communication. However, it operates properly.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>