3BEES U7 Fast Wireless Charging Pad User Manual

June 5, 2024
3BEES

3BEES U7 Fast Wireless Charging Pad

POWER

CHARGING

SPECIFICATIONS

3BEES U7 Fast Wireless Charging Pad
5

For the past and state charges, using a Quick Charge 2.0 or 3.0 Wall Charger is highly recommended. Other Chargers may not work well with this device.

Attentions

  1. Please keep the charger away from water or other liquids.
  2. Do not place the charger too close to any magnetic stripe or clip card (ID card, bank cards, etc) to avoid magnetic failure.
  3. This item is not to be used on any mobile device with metal plates, asit will cause extreme heat that may burn and/or damage the device.
  4. Fast charge via the plug and USB charging cable (both support QC 20 or QC 3.0)
  5. Usually, we recommend that the thickness of the phone case should be within 3 mm (0.12 inches). It would not charge if the thickness is more than 5 mm (O.19 inches).
  6. The standard temperature of wireless charger Ql is 130°F, but the temperature of our products should be controlled within 113″F. The charger will cut off the current when abnormal heating occurs. Please contact us if any damage occurs.
  7. We recommend that you turn off the power-consumption software before charging to effectively prevent the phone from overheating. When the temperature exceeds 113°F during charging, it is normal for the charging speed to slow down.

FCC STATEMENT

Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to IC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

IC Radiation Exposure Statement

This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals