newgarden X6 Garnald Allegra Cable Instruction Manual
- June 5, 2024
- newgarden
Table of Contents
newgarden X6 Garnald Allegra Cable Instruction Manual
See the warranty policy at www.newgarden.es
This product contains a light source of energy efficiency class C.
Warning
Read the instructions for use carefully before handling the product. NEWGARDEN cannot be held responsible if the usage guidelines and/or product recommendations described in these instructions have not been followed. IP44: Newgarden products with IP 44 can be used outdoors, they are protected against dust and light to very moderate rain. If this product also has accessories made of natural fibres, wood or metal parts, it is advisable to protect it from direct contact with water and moisture. Store in a dry place after use. In case of rain or very adverse weather conditions, it should be protected from the weather to avoid future problems. Follow these instructions to avoid falls, electric shocks, or installation and commissioning failures of the product. Keep these instructions for future use. Do not connect the garland to the power supply while it is in its packaging. Operating temperature from 0 to 4042C. Any internal changes to the lamp by the user will render the product out of warranty. This lamp is not protected against immersion in water, if installed improperly, it will cause accidents. Do not place the product next to heat sources, it could damage the product and in the last case, cause a fire. Keep combustible materials away from the bulbs. Do not allow the lamp or connector to come into contact with walls, fabrics associated with curtains, blinds or other materials. Lamps should hang freely in a downward direction with a minimum clearance of 10 cm from the nearest object. Do not wind the bulbs. In case of abnormal operation, switch off the product and contact qualified personnel. CAUTION – THIS LIGHT GARLAND MUST NOT BE USED UNLESS ALL SEALING GASKETS ARE IN PLACE. If extension cords are used, ensure that the connection is not located where water can accumulate. Avoid making connections and disconnections when the equipment is wet. When used outdoors in wet locations, the electrical installation to which it is connected must provide ground fault circuit interrupter (GFCI) protection. Use only within the voltage limits indicated. The product is powered at 85-265V and frequency 50/60Hz. Connect the product only with the supplied driver. Do not use a driver other than the one supplied. The product may be irreparably damaged. Do not use the product in case of damaged cable or broken lamp. In this case, it must be replaced exclusively by the manufacturer or Authorised Technical Service, in order to avoid any risk. LED bulbs can be replaced, in this case, only use bulbs supplied by the manufacturer or with the same technical characteristics required. Do not remove or insert lamps while the garland is connected to the mains supply. Make sure that all lamp holders are equipped with a lamp. It is possible to connect up to 4 garlands in series. provided they are of the same model. Do not interconnect parts of this garland with parts of another garland from another manufacturer. Interconnection must only be made using the connectors supplied. Any open ends must be sealed before use. Any modification to the luminaire by the user will render the product out of warranty. Only use components supplied by Newgarden Spain, SL. Any electronic components other than those supplied may seriously damage the operation of the product. For decoration only. This luminaire is not a toy. Do not allow children to play and manipulate the bulb.
- CE: Compliance with European Directives on Electrical Safety and Electromagnetic Compatibility.
- The crossed out trash can symbol on the appliance or packaging indicates that this product is the subject of a separate collection. Electrical and electronic equipment must be collected and not disposed of with household waste. Waste electrical and electronic equipment must be labeled with a collection system in accordance with Directive 2012/19 / EU. Electrical and electronic equipment is dangerous for the environment and human health due to the presence of a dangerous substance in its composition. Proper storage and collection of one of these products contributes to the protection of the environment and public health and constitutes basic conditions. Recycling of used electrical and electronic equipment. For more information on the delivery and collection of used electrical and electronic equipment. please contact your local authorities and the authorized collection center in this regard.
- A Class III appliance is designed to be powered by a SELV (Separated or Safety Extra Low Voltage) power source. The voltage of a SELV source is low enough that. under normal conditions, a person can come into contact with it without risking electric shock. Therefore. it is not necessary to incorporate the security that Class I and Class II appliances carry. Protection is not considered sufficient for compliance with Class III medical devices.
- In the event of a crack in the protection screen, it must be replaced.
- CMIN: Compliance with the regulations of the Kingdom of Morocco on Electrical Safety and Electromagnetic Compatibility, as the case may be.
You can connect up to 4 strings in series by connecting the male end to the female connector. If you connect more than the indicated number of units in series, the intensity of the light will decrease considerably.
CHANGE OF BULB:
- Switch o the power.
- Remove the bulb you wish to replace.
- Insert the new bulb, it must not exceed the specified power. Pay attention to its working voltage, 24V DC.
- Restore the power and check that everything works correctly
BULB A60 E27
OUTPUT 24V DC 0.2W/pc
INPUT 220/240V 50/60 Hz
35 LUMENS/pc
OPERATING INSTRUCTIONS
To switch on the garland, simply plug it into the power supply. To switch it off, unplug it from the main. MAINTENANCE INSTRUCTIONS IPeriodically inspect the cable and plugs for possible degradation. Replace the worn bulb promptly with a bulb that does not exceed the rated wattage. If any other part of the garland is damaged, it must be replaced quickly. WARNING – RISK OF ELECTRIC SHOCK IF BULBS ARE MISSING OR BROKEN. DO NOT USE.
INSTALLATION INSTRUCTIONS
The garland is supplied with an 8m cable with 2 connectors at its ends: one male and one female. The transformer has a female connector, so it is assembled with the male connector of the cable. For installations with garlands it will be necessary to use guides with steel cable or another support system, such as S-hooks, screw hooks or flanges (Not included). Do not use nails, staples or other sharp, conductive materials to attach the garland to the structural support. DO NOT DAMAGE THE WIRE. Bulbs should be facing down.
NEWGARDEN SPAIN SL
Av de Francia 5-15 P. 1 . Las Salinas 30840 Alhama de Murcia.
Murcia. Spain. T +34 968 978 806
www.newgarden.es