OLIGHT Seeker 2 Rechargeable LED Torch User Manual

: June 5, 2024
: OLIGHT

Table of Contents

OLIGHT Seeker 2 Rechargeable LED Torch
SPECIFICATIONS
PRODUCT OVERVIEW
HOW TO OPERATE
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

OLIGHT Seeker 2 Rechargeable LED Torch

IN THE BOX

SPECIFICATIONS

All performance measurements in accordance with ANSI/NEMA FL1-2009 standards.
The minimum output at Turbo and high mode is 600 lumens.

PRODUCT OVERVIEW

BEFORE FIRST USE

BATTERY LEVEL INDICATOR

NOTE: Under moonlight, when the battery power is more than 10%, the indicator won’t turn on; when the battery power is less than 10%, the indicator will light up red or the red indicator blinks. ****

CHARGING

Connect the magnetic USB end of the charging cable (MCC1A) to an external USB power source , then attach the other end ofthe magnetic charging cable to the charging port. It takes no more than 6 hours to fully charge the light
Before first use please fully charge the product.

HOW TO OPERATE

ON/OFF: Single-click the side switch to turn the light on/off. When the light is turned on, it will return to the previous brightness level selected before the light was turned off. (Only the moonlight, low, medium and high mode can be memorized when the flashlight is switched off. The turbo mode is memorized as high mode. The strobe mode cannot be memorized).

CHANGE BRIGHTNESS LEVEL: When the flashlight is on, press and hold the side switch to automatically cycle through the moonlight, low, medium, high, and low modes. The mode is selected when the side switch has been released.

MOONLIGHT: When the flashlight is off, press and hold the side switch for about one second to access the moonlight mode.

DIRECT ACCESS TO TURBO: Enter and exit Turbo mode: quickly double click the side switch to enter Turbo mode, and quickly double-click the side switch again to exit Turbo mode.When the memorized mode is on high, quickly double- click the side switch to exit Turbo mode and switch to medium mode. When the memorized mode is Medium, Low, or Moonlight, quickly double click the side switch to exit turbo mode and switch to the previously memorized mode.

STROBE: When the flashlight is on, triple-click the side switch to activate strobe mode. To quit this mode, single click or press and hold the switch.

TIMER: The Seeker 2 has a long (9 minutes) and short (3 minutes) timer when the light needs to be automatically turned off. When the flashlight is on, double click and hold the side switch under the current brightness level to access the timer settings. A single blink accesses the short-timer while two blinks access the long timer. The flashlight will automatically turn off when the timer is up. After the timer is set, double click and hold the side switch to shift the timer settings. When the timer is up and the user is about to enter the timer again, the light will return to the last timer setting.

LOCKOUT/UNLOCK : When the flashlight is off, press and hold the side switch (for about 2 seconds) to access the button lockout mode (the flashlight will enter the moonlight mode first and will then switch off to signal the lockout mode). Under the lockout mode, press and hold the switch for less than one second without releasing it. The red indicator below the switch will be on for a short time to signal that the light is still in a lockout mode. To unlock it, keep holding switch for over one second until the moonlight mode is on again.