YIEUS 6-in-1 RGB Interior Car Lights User Manual
- June 5, 2024
- YIEUS
Table of Contents
YIEUS 6-in-1 RGB Interior Car Lights
Installation Steps
- Measure the length of the part to be installed, then cut the same length on the optic fiber and the transparent tube (the optic fiber needs to be 0.35in longer than the transparent tube for connecting the light strip).
- Pass the cut optic fiber through the transparent tube from.
- Install the transparent tube with fiber optics in the location where it needs to be installed (use the included tool to pry open the slit in the location to be installed).
- Link one of the light strips to the transparent tube installed in step 3.
- For other locations in the car that need to be installed just repeat the above steps.
- Place the wires and LED lights in the appropriate location (can be hidden in the center console, under the footrest or other places).
- connect the cigarette lighter to the controller, power up.
APP Linking Steps
- Scan the QR code on the controller to download the APP; or download the APP in Google Play or APP Store (APP name: Lotus Lantern).
- Turn on your cell phone Bluetooth.
- Power up the light strip.
- Open the APP and click the button on the top left corner of the interface to link (connect in this APP).
Installation Location
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Caution: Changes or modifications not expressly approved by the party responsible for Compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, p ursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against h armful interference in a residential installation. This equipment generates uses and can radiate radio freq uency energy and, if not installed and used in accordance with the instructions, may cause harmful interfe rence to radio communications. However, there is no guarantee that interference will not occur in a partic ular installation. If this equipment does cause harmful interference to radio or television reception, which c an be determined by turning the equipment off and on, the user is encouraged to try to correct the interfer ence by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help with important announcements.
Radiation Exposure Statement
To comply with FCC RF exposure compliance requirements, this grant is applicable to only mobile configurations. The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>