CENTURION SDO4 Smart Garage Door Operator Installation Guide
- June 24, 2024
- CENTURION
Table of Contents
CENTURION SDO4 Smart Garage Door Operator
INSTALLING AND CONFIGURING UNIT WITHOUT MAINS POWER (BATTERIES ONLY)
Please ensure to connect the battery harness (two blue connectors) in the battery box, before continuing.
Please note that this version of the SDO4 SMART garage door operator
allows you to power up the unit without mains voltage being present. The My
Centsys Pro mobile application can also be used to enable Sleep Mode during
prolonged power outages.
The battery voltage must be within the required limits to allow the SDO4
SMART to be powered up. Refer to technical specifications.
The battery voltage must
be within the required limits to allow the SDO4 SMART to be powered up.
Refer to technical specifications.
To power up/activate the unit, please follow the steps below using the Courtesy Light Switch:
- Press and hold the Courtesy light for 3-5 seconds, and release (Light will flash three times)
- Set up limits and configurations using the My Centsys Pro Mobile Application
- Place the unit back into “Sleep Mode” to conserve battery life using My Centsys Pro Mobile Application
The SDO4 SMART will
automatically power up once mains has been restored.
This function is only
available with PCB V1.3, and Firmware V1.10.1.0 or later.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>