MALYAN MA20 FDM Belt 3D Printer User Manual
- June 5, 2024
- MALYAN
Table of Contents
MA20 FDM Belt 3D Printer
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation. -Reorient or relocate the receiving antenna. -Increase
the separation between the equipment and receiver. -Connect the equipment into
an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm etween the radiator & your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>