Playmind 000-00056 Overtake RC Remote Control Stunt Car Instruction Manual

June 5, 2024
Playmind

000-00056 Overtake RC Remote Control Stunt Car
Instruction Manual

WARNING! All rubber bands, plastic headbands, and wire ties, as well as tags, are not part of this toy and should be discarded for your child’s safety.

Operation requires 4 “AA” 1.5V alkaline batteries (not included) for the car and one 9V battery (not included) for remote control.

  1. Carefully remove items from the package.
  2. Locate the battery compartment on the back of each item (see diagram below).
  3. Swivel latches on the bottom of the car to release battery pack and insert batteries.
  4. Switch both car and remote buttons to the “ON” position.
  5. For the best results use the car on hard surfaces such as wood or tile.

WARNING:
Battery Information and Instructions
Requires 4 x AA (1.5V) size batteries + 1 x 9V battery (Battery not included.)
Always purchase the correct size and grade of battery.
Replace all batteries of a set at the same time.
Do not mix old and new batteries. Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries. Clean the battery contacts and those of the device prior to battery installation.
Ensure the batteries are installed correctly with regard to polarity (+ and -).
Remove batteries from equipment that is not to be used for an extended period of time. Remove used batteries promptly. RECYCLE YOUR BATTERIES: Battery recycling is recommended.
Find a local recycling center at http://earth911.com/recyclIngisingle-use- batteries/

GENERAL CONTROL

Playmind 000-00056 Overtake RC Remote Control Stunt Car - figure
1

SPINNING ON REAR WHEEL (ACTION BUTTON)

Playmind 000-00056 Overtake RC Remote Control Stunt Car - figure
2

REMOT CONTROL ASSEMBLY

BATTERY DIAGRAM

SAFETY PRECAUTIONS

  • Do not operate during thunderstorms or rain.
  • Avoid water, sand, and snow when operating a car.
  • Do not submerge car or controller in water.
  • Never operate your car on the street or highway.
  • Never operate your car in a confined or crowded area. and do not use people or animals as obstacles.
  • Do not run your car into furniture, objects, or hard surfaces, as this will cause damage to both the objects and the car
  • Keep fingers, hair, and loose clothing away from the tires, gears, and motor while the car is switched to ”ON”.
  • Do not leave the car or transmitter near sources of heat or under direct sunlight for long periods of time.
  • Do not leave the car or transmitter outside overnight. Dampness is harmful to interior components.
  • Remove all batteries when not in use to avoid accidental operation.
  • Adult supervision is recommended when operating this car.

FCC WARNING

This device complies with Part 15 of the FCC Rul Operation and is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for Class B digital devices. pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio or television reception, which can be determined by turning the equipment off arid or, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and the receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

MANUFACTURED BY:
© PLAYMIND LTD.
63 Mody Road, Tsim Sha Tsui East, Kowloon, Hong Kong
Visit us at: www.playmindltd.com
Made in Shantou, China
Distributed by Inter-American Products, 1014 Vine St., Cincinnati, OH 45202
Colors and decoration may vary Please keep the packaging for future reference Playmind 000-00056 Overtake RC Remote Control Stunt Car -
ce

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

Related Manuals