shenzhen infell eletronics ZSJ-1708-01 Remote Controller Instructions
- June 13, 2024
- shenzhen infell eletronics
Table of Contents
Users Manual
ZSJ-1708-01 Remote Controller
Remote Controller
Model No:ZSJ-1708-01
Parameter:
Input:DC3V, Working current≤15mA,quiescent current≤3uA;
Transmission frequency:433.92MHz
Shell temperature resistance value:≤60℃
antenna gain:2dBm
Dimension: 142507mm
FCC Statement:
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:–Reorient or relocate
the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
MODIFICATION: Any changes or modifications not expressly approved by the
grantee of this device could void the user’s authority to operate the device.
IC Statement:
This device contains licence-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s licence-exempt
RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
| ICONS | Operational matters |
|---|---|
| 1.Press the light on and off |
2.Power on within 10 seconds, long press the code for 3 seconds
| Press the switch fan
| Short winter/Summer mode: Convert winter/summer mode
| Can be set for 1,2,4 hours
Short press the timing, 1H corresponds to 1 hour, 4H corresponds to 4 hours… .
The timing can only be canceled by shutting down the fan
| Increase and decrease wind speed for 6 gears
| 1.Long press the dimmer key “+” Electrodeless dimming is performed. The
brightness can be increased slowly until the maximum brightness is reached (4s
time from lowest to highest)
2. Press the dimmer key “+” to step dimming Increase brightness by gear to
maximum brightness, for a total of 8 stops.
1. Hold down the dimmer key – to perform endless dimming. Can slowly reduce
the brightness to the lowest brightness
2. Press the dimmer key “-” to step dimming Reduce brightness to maximum
brightness by gear, 8 stops in total
| Press the corresponding key to adjust the color temperature of the light
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>