ADVENTURE FURTHER 2-LIGHT 40A Relay 160W Wire Harness Instruction Manual
- June 3, 2024
- ADVENTURE FURTHER
Table of Contents
ADVENTURE FURTHER 2-LIGHT 40A Relay 160W Wire Harness Instruction Manual
IMPORTANT:
Please read all instructions before beginning installation. These
guidelines are provided in good faith to help prevent any issues arising from
errors during installation. The manufacturer of this product shall not be held
responsible for any user actions taken or not taken during installation. There
are many details of the installation that are assumed to be general mechanical
knowledge to experienced installers; which are not detailed in these
instructions. These installation guidelines are intended to serve as
professional recommendations and are not as a step-by-step, fail-safe
installation checklist. Selection of an experienced installer is the sole
responsibility of the project owner.
Parts Included
- (1) Wire Harness
- (1) Switch
- (1) Relay
- (6) Wire Ties
STEP BY STEP INSTALLATION INSTRUCTIONS
Mounting Your Lights:
After choosing a location to mount your lights, install and loosely tighten
before installing the wire harness.
Wiring Your Lights:
Before starting, make sure to remove the 3A fuse in-line to the switch and
relay for safety.
- Begin by routing the KC wire harness safely from the battery (or power source), away from any moving parts and connect the lights to the harness.
- Next, route the three switch leads (spade connectors) toward the desired switch location. To install the switch, drill a ¾” hole in the desired location to press the switch into. (Note: Do not install switch until you have the switch wires routed to the switch location, and then attach the switch wires accordingly before pressing the switch into the mounting hole). Connect the switch wires as follows: WHITE to Terminal-3 behind (=) indicator on switch, YELLOW to Terminal-2 (center), and GREEN to Terminal-1 behind (-) indicator on switch.
- Mount the Relay close to the battery with blades facing down (sheet metal screw provided). Connect the Yellow Power lead (with ring terminal) to the (+) Positive side of the battery. Connect the Black Ground lead (with ring terminal) to the (-) Negative side of the battery or chassis ground.
Connect & Test:
After the harness has been secured and the Power & Ground properly connected.
Re-install the removed 3A fuse and the relay. Test the lights by toggling both
Low (-) and High (=) on the Rocker Switch.
Copyright 2020 KC HiLiTES, Inc. Rev:05112020
KC3264QC REV 1
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>