BARTON 95184 Electric Fireplace Instruction Manual

CANF-20

ELECTRIC FIREPLACE

Installation Instructions

WARNING! IF THE INFORMATION IN THIS MANUAL IS NOT FOLLOWED EXACTLY, A FIRE
MAY RESULT IN CAUSING PROPERTY DAMAGE, PERSONAL INJURY, OR LOSS OF LIFE.

FOR YOUR SAFETY

DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE VAPORS OR LIQUIDS IN THE VICINITY OF THIS OR ANY OTHER APPLIANCE
DO NOT DISCARD THIS MANUAL – LEAVE IT FOR THE HOMEOWNER
CUSTOMER: PLEASE RETAIN THIS MANUAL FOR FUTURE USE

IMPORTANT: Read all instructions and warnings carefully before starting installation. Failure to follow these instructions may result in a possible electric shock, or fire hazard and will void the warranty.

SPECIFICATIONS:

Model: CANF-20

AC120V/ 60Hz 1500W fireplace 2 heat settings: Low/High 6 level flame brightness Overheat protection  Flame without heat optional 8 hours on/off timer Remote control

SAFETY FEATURES

Overheat Safety Feature
This appliance comes equipped with an overheat protection safety device. Should the appliance begin to overheat for any reason, it will automatically turn all heater functions of the appliance off. The appliance will have to be reset prior to continuing use. To reset the overheat protection safety device, turn all controls off and unplug the appliance. Wait 10 minutes, plug the appliance back in and turn it on.

WARNING: It is normal for the power cord to feel warm to the touch; however, a loose fit between the outlet and the plug may cause overheating of the plug. If this occurs,  try inserting the plug into a different outlet. Contact a qualified electrician to inspect the original outlet for damage.

INTENDED USE: This product is intended only for indoor household or office use.
It is NOT intended for industrial or commercial use. DO NOT USE OUTDOORS

IMPORTANT INSTRUCTIONS

PLEASE READ AND SAVE THESE IMPORTANT SAFETY INSTRUCTIONS When using electrical appliances, basic precautions should always be followed to reduce the  risk of fire, electrical shock, and injury to persons, including the following:

1. Read all instructions before using this heater.
2. This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. If provided, use handles when moving this heater. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes, and curtains at least 3 feet (0.9 m) from the front of the heater and keep them away from the sides and rear.
3. Extreme caution is necessary when any heater is used by or near children or invalids and whenever the heater is left operating and unattended.
4. Always unplug the heater when not in use.
5. Do not operate any heater with a damaged cord or plug or after the heater malfunctions, has been dropped, or damaged in any manner. Discard the heater, or return it to an authorized service facility for examination and/or repair.
6. Do not use outdoors.
7. This heater is not intended for use in bathrooms, laundry areas, and similar indoor locations. Never locate a heater where it may fall into a bathtub or other water container.
8. Do not run cord under carpeting. Do not cover the cord with throw rugs, runners, or similar coverings. Do not route the cord under furniture or appliances. Arrange cord away from traffic area and where it will not be tripped over. 9) To disconnect the heater, turn the controls off, then remove the plug from the outlet.
9. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or damage the heater.
10. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use it on soft surfaces, like a bed, where openings may become blocked.
11. Do not use it in areas where gasoline, paint, or flammable liquids are used or stored.
12. Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons.
13. Always plug heaters directly into a wall outlet/receptacle. Never use an extension cord or relocatable power tap (outlet/power strip).
14. CAUTION: This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of shock, this plug is intended to fit only one way in a polarized outlet. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. DO NOT attempt to defeat this safety feature.

ZONE HEATING SAVES!

The concept of Zone Heating is simple. Use High-Efficiency heaters to heat the rooms you use most, during the times you use these areas, and turn back the thermostat to your central heating system. To achieve the maximum benefit it is important to understand your heater and where best to locate it.

Please follow these suggestions:

1. Close doors to areas you do not wish to heat.

2. Locate an outlet along an interior wall if possible. Position the heater so that the warm air can blow
   unobstructed across the room towards the exterior walls.

3. Check your windows and doors for the infiltration of cold air and insulate as needed to avoid heat loss. Rapid heat loss will minimize the effectiveness of your heater as it would any conventional type heater.

4. Keep the area around the heater free of obstructions to ensure maximum airflow. Keep electrical cords, drapery, furniture, and other combustibles 3 feet (0.9 M) away from the front of the heater and away from the sides.

5. Avoid locating your heater in high-traffic areas or in direct sunlight.

6. Avoid locating your heater near your central heating thermostat.

INSTRUCTIONS FOR POWER

WARNING: Before servicing this heater be sure to unplug the heater from the wall outlet.
Do not only turn off the heater from the main “ON/OFF” switch but be also sure to unplug this heater.

ELECTRICAL CONNECTION
AC120Volt, 60Hz circuit with a properly grounded outlet is required. Preferably, the heater will be on a dedicated circuit. Other appliances on the same circuit may cause the circuit breaker to trip or the fuse to blow when the heater is in operation. The unit comes standard with a two-wire cord exiting from the rear of the appliance.

WARNING: Electrical outlet wiring must comply with local building codes and all other applicable regulations to reduce the risk of fire, electrical shock, and injury.
WARNING: Do not use this appliance if any part of it has been underwater. Immediately call a qualified service technician to inspect the appliance and replace any part of the electrical system if necessary.

PRODUCT DIAGRAM

OPERATING YOUR HEATER

1. First, turn on the Power switch on the right side of the heater. You will hear a beep indicating power is supplied to the unit. The Power switch supplies power to all the functions of the appliance. This switch must be in the “ I” position for any functions including the remote control to work.
2. Setting Temperature

| Press the Power button, and the heat and flame effect will be on. Press the Power button again, heat and flame effect will be off. The fan will continue running for 30 seconds to disperse the remaining heat from inside.
---|---

2. Setting timer to power-off

| Press the Timer button to set the timer-power-off function through the control panel. Press the Timer button to increase the duration from 1h-2h-3h- 4h-5h…….8h. The display panel will show 01-02-03-04-05…08.
---|---

3. Setting the heat

| Press the Heater button on the control panel, the heater will start, it is the Low heating model, The display panel show LL, press it once again, it is High heating mode, The display panel show HH press the button the third time, the heater will be off, the fan will continue running for 30 seconds to disperse remaining heat from inside. When LL or HH is displayed, the heater is normally open and is not affected by temperature control.
---|---

4. Setting Temperature

| Control temperature settings to choose temperature as desired . Setting range from 62 F to 82 F. Press once. Indicator light turn  on.Temperature is set to 62 F. Increase 2F per press. 14 Settings display: （62,64,66,68,70,72,74,76,78,80,82,84,86,88）
---|---

5. Setting flame

| There are 6 brightness levels that can be selected for work.
Settings 1 -3 increase in brightness with flicker.
Settings 4 -6 increase in brightness without flicker.
---|---

  MAINTENANCE

1. Turn off the heater of the power switch.
2. Unplug the unit and let it cool completely.
3. To keep the heater clean, the outer shell may be cleaned with a soft, damp cloth. You may use a mild detergent if necessary. After cleaning, dry the unit with a soft cloth.  CAUTIO N: DO NOT let liquid enter the heater.
4. DO NOT use alcohol, gasoline, abrasive powders, furniture polish, or rough brushes to clean the heater. This may cause damage or deterioration to the surface of the eater.
5. DO NOT immerse the heater in water.
6. Wait until the unit is completely dry before use.

TROUBLESHOOTING

IF YOU EXPERIENCE DIFFICULTIES, PLEASE DO NOT RETURN THIS PRODUCT TO THE STORE
For assistance with this appliance, please call our customer service department.

off, unplug the appliance,  allow cooling for at least 10 min plug back in and restart.
The appliance turns off and will not turn back on.| The overheat protection of the device in the appliance has been triggered.| Turn all controls off, unplug  the appliance,  allow cooling for at least 10 min., plug back in
The appliance does not turn on  when the  button is pushed to “ON”| The overheat protection device in the appliance has been triggered| Turn all controls off, unplug the appliance,  allow cooling for at At least 10 min., plug back in and restart.

ALWAYS OBSERVE THESE SAFETY PRECAUTIONS WHEN OPERATING YOUR ELECTRIC HEATER

ALWAYS read all instructions before operating.
ALWAYS Locate your electric heater away from furniture or loose hanging drapes.
ALWAYS Keep the rear grill away from walls or drapes so as not to block the air intake. (If applicable)
ALWAYS Unplug the electric heater when not in use.
ALWAYS Use an electric heater on a flat dry surface.
ALWAYS Use on 120 volts 60Hz AC power supply.
ALWAYS Route the cord so it will not be walked on, tripped over, or pinched by furniture.
ALWAYS Keep electrical cords, drapes, and other furnishings away from your electric heater.
ALWAYS Keep your electric heater clean and the filter free of dust. (If applicable)
ALWAYS Use indoors only.
NEVER Place drapes, clothing, or towels over the electric heater to dry.
NEVER Use in the presence of explosive or flammable vapors such as gas or paint.
NEVER plug another electrical appliance into the same circuit. Blown fuses tripped circuits, and fire hazards may result.
NEVER Use water or liquids to clean your electric heater.
NEVER let bare skin touch hot surfaces as this may cause burns.
NEVER Leave the electric heater unattended.
NEVER Leave the electric heater unattended when children or pets are present.
NEVER Locate an electric heater where it may fall into a bathtub or other water containers.
NEVER Operate an electric heater with a damaged cord, plug, or after the heater malfunctions, or has been dropped or damaged in any manner.
NEVER run cord under carpeting or cover with throw rugs or runners.
NEVER insert or allow foreign objects to enter any ventilation or exhaust openings, as this may cause an electrical shock, fire, or damage.

ELECTRIC HEATER WARRANTY

LIMITED WARRANTY:
A limited warranty is extended to the original p to manufacturing defects for a period of (1) one year from the date of retail purchase. Please read and follow all details noted below.

DUTIES OF THE OWNER:
This heating appliance must be operated in accordance with the written instructions furnished with this heater.
This warranty shall not excuse the owner from properly maintaining this heater in accordance with the written instructions furnished with this heater. A bill of sale, canceled check, or payment record must be kept to verify the purchase date and establish the warranty period. The original carton should be kept in case of a warranty return of the unit.

WHAT IS NOT COVERED:

1. Damage caused by misuse or use contrary to the owner’s manual and safety guidelines.
2. Damage caused by a lack of normal maintenance.
3. Repair by an unauthorized person.
4. Damage caused by connection to an improper voltage.
5. Damaged caused by use outdoors.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>