HomeSpot JY100 Wireless Neckband Headphones User Manual

HomeSpot JY100 Wireless Neckband Headphones

Package Contents

Product Overview

Charging & Battery Status

We recommend charging the HomeSpot JY100 JY10x with a 5V 500mA or 5V 1A USB power source. Power adapters or chargers that supply more than 5.5V will damage the JY100 JY10x and should not be used.
Step 1
Using the micro-USB cable, connect the JY100 JY10x to a USB power source. Step 2
LED indicator will be red when charging, and will be off when the JY100 JY10x is fully charged.

• It takes up to 3 hours to fully charge a JY100 JY10x and it can provide about 8 hours of listening time.
• 20 minutes of charging gives about 1 hour of listening time.
• To check the JY100 JY10x battery level, press the Volume +/- key when the JY100 JY10x is idle (not on a call or music playing).
• When battery level is below 10%, there will be a periodic warning tone and the LED indicator will flash in red.

Pairing

1. With the JY100 JY10x turned off, press and hold the MFB key until you hear the “Pairing” voice prompt and the LED indicator starts flashing red and green.
2. Turn on the Bluetooth function on your mobile device, search for, and pair with “HomeSpot JY100 JY10x”.
3. Once paired, you will hear the “Connected” voice prompt and the LED indicator will be green.
4. Next time when turning on the JY100 JY10x, it will try to reconnect to the previously paired device.

Controls

| Power on| Press and hold the MFB key for 1 second
---|---|---
Power off| Press and hold the MFB key for 4 seconds
Play/pause music| Press the MFB key during music playing
Answer/end call| Press the MFB key during call
Reject call| Double press the MFB key
Activate voice assistance

(Siri, OK Google)

| Press and hold the MFB key for 1 second when not on a call
Set JY100 JY10x

to pairing mode

| Turn off JY100 JY10x, then press and hold the MFB key for 4 seconds
Reset JY100 JY10x| Turn off JY100 JY10x, then press and hold the MFB key for 7 seconds, JY100 JY10x will go into pairing mode after reset

| Adjust volume| Press the Volume +/- key during call or music playing
Next/Previous song| Press and hold the Volume +/- key for 1 second during music playing
Check battery level| Press the Volume +/- key when the JY100

JY10x is idle (not on a call or music playing)

Mute microphone| Press and hold the Volume – key for 1 second during call

Note: There will be a periodic reminder tone when microphone is muted

Un-mute microphone| When microphone is muted, press the Volume +/- key to un- mute

Specifications

Troubleshooting

WARNING: Due to the isolating characteristics of these headphones do not use while driving, riding a bike or where vehicular traffic is present, or in any other activity where failure to hear surrounding sounds could be dangerous. Use of these headphones at excessive volumes may cause permanent hearing damage. Always turn the volume down before use. Take caution in regards to inserting objects into ear canal, use at own risk.
COMPLIANCE
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interfer-ence in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna. – Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This equipment must not be co-located or operated in conjunction with any other antenna or transmitter.
Caution: Any changes or modifications to this device not explicitly approved by the manufacturer could void your authority to operate this equipment.
TRADEMARK

• Siri is a trademark of Apple Inc., registered in the U.S. and other countries.
• OK Google is a trademark of Google LLC.
• The Bluetooth® word mark and logos are owned by Bluetooth SIG, Inc. and any use of such marks by HomeSpot® is under license.
• Qualcomm aptX is a product of Qualcomm Technologies, Inc. and/or its subsidiaries.
• Qualcomm is a trademark of Qualcomm Incorporated, registered in the United States and other countries. aptX is a trademark of Qualcomm Technologies International, Ltd., regis-tered in the United States and other countries.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>