greenworks 5203502 Surface Cleaner Owner’s Manual
- June 5, 2024
- Greenworks
Table of Contents
GreenWorks 5203502 Surface Cleaner
SAFETY INSTRUCTIONS
WARNING: Please read and comply with these original operating instructions prior to the initial operation and store them for later use or subsequent owners.
- Please read the safety instructions of your pressure washer.
- Make sure there are no persons in the immediate vicinity of the cleaning head.
- Turn off the pressure washer when you finish cleaning.
- Maximum water temperature 104 °F (Please read the instructions of your pressure washer).
- Wear eye protection with side shields that are marked to comply with ANSI Z87.1 when operating this equipment.
After use or before servicing, always disconnect the surface cleaner from the pressure washer spray wand.
SYMBOL
PRODUCT INFORMATION
If any parts are damaged or missing, please call 1-888-90WORKS (888.909.6757) for Greenworks customer service.
PRODUCT SPECIFICATIONS
- Connection …………1/4 in. Quick Connect Plug Inlet
- Cleaning Width…………………………………………..15 in.
- Maximum Pressure …………………….Up to 3100 PSI
- Maximum Water Flow……………………………2.5 GPM
- Maximum Water Temperature…………………… 104°F
KNOW YOUR SURFACE CLEANER
- 1/4 in. Quick Connection
- Casing
- High-Pressure Nozzle
- Rotor Arm
Proper use
This surface cleaner can be used on various materials, including plastic,
concrete, tiles, natural stone, and more.
APPLICATION
Cleaning floor surface
Fastern the surface cleaner to the high pressure 1/4 inch quick connect spray
wand. See fig 2
- Pull back the quick-connect collar
- Push the surface cleaner into place
- Push the collar forward.
- Pull the trigger gun to operate the machine
Tips for cleaning
- Outdoor surfaces should be swept before the surface cleaner is used to avoid damaging the high pressure nozzles.
- The surface cleaner is not suited for scouring or scrubbing.
- If striping or swirl marks occur, slow your pace.
- If striping or swirling continues, the surface cleaner nozzle(s) may be clogged. Disconnect surface cleaner from pressure washer spray wand before servicing. Using a straightened paper clip or nozzle cleaning tool (not provided), free any foreign materials clogging or restricting the nozzle.
Caution
Do not run over free standing corners. DO NOT lift or tilt the surface cleaner
from a horizontal surface while connected to the spray gun during operation.
GENERAL INFORMATION
Care Use a moist cloth and clean surface cleaner after use.
WARRANTY
Greenworks hereby warranties this product, to the original purchaser with
proof of purchase, for a period of three (3) years against defects in
materials, parts or workmanship. Greenworks, at its own discretion will repair
or replace any and all parts found to be defective, through normal use, free
of charge to the customer. This warranty is valid only for units which have
been used for personal use that have not been hired or rented for industrial
commercial use, and that have been maintained in accordance with the
instructions in the owners’ manual supplied with the product from new.
ITEMS NOT COVERED BY WARRANTY:
- Any part that has become inoperative due to misuse, abuse, neglect, accident, improper maintenance, or alteration.
- The unit, if it has not been operated and/or maintained in accordance with the owner’s manual.
- Normal wear, except as noted below.
- Routine maintenance items such as lubricating or sharpening.
GREENWORKS HELPLINE
(1-888-909-6757):
Warranty service is available by calling our toll-free helpline at
1-888-909-6757.
TRANSPORTATION CHARGES:
Transportation charges for the movement of any power equipment unit or
attachment are the responsibility of the purchaser. It is the purchaser’s
responsibility to pay transportation charges for any part submitted for
replacement under this warranty unless such return is requested in writing by
Greenworks.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>