SUMMIT VIEW SUTV-2010 UTV 1080p Rear Vision System with High Definition 7″ DVR Monitor Instruction Manual
- June 5, 2024
- SUMMIT VIEW
Table of Contents
SummitViewTM UTV 1080p Rear Vision System
with High Definition 7 DVR Monitor
SUTV-2010
Recommended Tools
Difficulty Level
Install Time
2hr – 3hr
Product Features
Questions? Call the Brandmotion technical support line at 734-619-1250 or CLICK HERE
Kit Contents
Components for installing the HD Monitor
Kit B
Components for installing the Off-Road Camera
Camera Installation
Part 1
Mounting hardware installation
- Remove the 4 Allen screws that are located on the sides of the camera and remove the camera mounting bracket and visor.
- Find an appropriate place to mount the camera. Line up the foot bracket to ensure that there is enough space to attach the camera to the body.
- Attach the mounting foot using either self-tapping screws or a bolt and nut.
- Use a 1″ hole saw to drill a hole for the camera harness`
Part 2
Camera mounting
- Feed the harness through the drilled hole, fit the grommet to the inside of the hole.
- Reattach the camera and visor to the mounting bracket. Make sure the camera is oriented UP by seeing the light sensor on the right side of the camera when looking at it.
- Route the camera harness to where the display is located.
- Connect the 4-pin to RCA cable to the end of the harness at the display end. (This wont be needed anymore, all connections are 4 pin)
Monitor Installation and Wiring
Part 1
Roll Bar Mount
- Choose the proper size roll bar mounting ring.
- Use the supplied foam and apply to the inner ring of the bracket.
- Place the mounting ring on the desired location. A fair amount of force might be necessary.
- Attach the neck of the mounting bracket to the mounting ring, and tighten the cross bolt. a). Note: If there is still movement in the monitor bracket mount, lay 1 to 2 strips of electrical tape between the roll bar and the bracket base.
Part 2
Vehicle Wiring
- Connect the RED to the 12-volt accessory.
- Connect the BLACK to the ground.
- Connect YELLOW to 12-volt constant power.
Part 3
Camera Wiring
- Connect the GREEN wire to select parking.
- Connect the White
- The BLACK connector is for the power plug.
- loop on the camera harness.
FAQ Section
-
How do I stop the monitor mount from moving on the roll cage?
We recommend adding a strip of electrical tape to the mounting plate in order to create a tighter fit. -
How do I turn off the monitor?
Hold down the power button for 3 seconds. -
Is the monitor waterproof?
The cameras are rated for IP 69K, however, the monitor is not waterproof. We recommend mounting it high on the roll bar to prevent the possibility of submerging the unit. -
What type of battery does the remote use?
The remote uses a 2032 3V battery.
WARNING
Cancer and Reproductive Harm
www.P65Warnings.ca.gov
Installation Instructions – UTV Camera System
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>