iScooter M5 Pro Electric Scooter User Manual
- June 3, 2024
- iScooter
Table of Contents
iScooter M5 Pro Electric Scooter
The manufacturer reserves the right to make changes to the product, and update this manual at any time.
Before Use
About the Product
Components
1. LED Display | 14. Tail Lights |
---|---|
2. Handle | 15. Reflective Sticker |
3. Brake | 16. Rear Wheel |
4. Accelerator/ Throttle | 17. Disc Brake Disc |
5. Headlight | 18. Front Fender |
6. Lever Bar | 19. Motor |
7. Rubber Flap Hole | 20. Reflective Sticker |
8. Fixed Leg | 21. Kickstand |
9. Folding Bar | 22. Bottom Cover |
10. Folding Spanner | 23. Side LED Lights |
11. Anti-slip Pedal | 24. Frame |
12. Rear Fender | 25. Bell |
13. Disc Brake | 26. Electronic Brake |
Operation Panel
Product Specifications
Accessories
Note:
Please check out all the items in the package carefully. If there is anything
missing or damaged, please contact us for support.
Assembly
Unfold the stem and press hard to lock the folding mechanism. Then put the kickstand down.
Attach the handlebar to the stem.
Install four screws (two for each side) with the attached hexagon wrench.
After the assembly, press the power button to check if it works normally
Notes:
- Do not allow children to install the product, and keep them from eating the items by mistake or installing the scooter incorrectly.
- When installing the handlebar, please be aware to align the screws to corresponding positions. There are 2 Screws for each side. Find out the holes and twirl the screws into the holes correctly to avoid the installation error.
- Do not touch and probe the power supply with your hands or with conductive objects (such as iron wires,nails, pins, etc.), and keep your hands dry.
Charging
Notes:
- Remember to fix the rubber flap after charging
- Do not turn on the scooter when it is charging.
- Do not wet the charger, otherwise there is a danger of short circuit or even fire.
- Do not connect the charger iT the charging port is wet.
- The scooter is fully charged when the LED on the charger changes from red (charging) to green (trickle charge). Cover the charging port when not in use.
- Under no circumstances should you use any charger other than the one provided to charge the scooter. In addition, the attached charger can only be used to charge this scooter
Folding and Carrying
Make sure that the scooter is turned off.
To unfold, first press thee small red button in the middle of the folding
spanner, then pull the folding spanner downward, and lift the handle, pushing
with strength until hear a “click
To fold, first press the small red button in the middle of the folding
spanner, then pull the tolding spanner and push the foldingbar down until you
hear a “click”
After the SCOoter is folded, simply lift it by the stem to carry.
Note:
Do not lift the rear fender when carrying the scooter, or it will be broken.
The company will not be responsible for this situation. After folding the
scooter, please carry the Scooter by lifting the stem.
Safety Precautions
Please read this manual carefully before using the product.
Riding Notice
- Helmet and other protective equipment are strongly recommended.
- It is forbidden to use this product on vehicle driving routes or dangerous terrain. Respect current laws and regulations.
- Drive slowly or reduce speed on poor-quality sidewalks.
- Not suitable for minors under 16 years old.
- Do not step over sidewalks or stairs more than 3cm high.
- Do not water the scooter.
- Do not use on oily ground or snow.
- Do not use it the temperature iS below or equal to-5C.
- Do not use the scooter with one hand.
- Do not step on the rear tender.
Warnings and Prohibitions
- Do not ride in the rain.
- Do not ride in ponding above 0.78 inches or puddles more than 4cm deep.
- Do not accelerate when you go downhill.
- Do not press the accelerator when you’re walking alongside the scooter.
- Do not hang bags or other heavy stuff on the handlebar
- Do not ride in traffic lanes or residential areas where vehicles and pedestrians are both allowed.
- Do not turn the handlebar violently during high-speed riding.
- Do not ride with anyone else, including children.
- Keep both feet on the deck all time.
- Always steer clear of obstacles.
- Look out for doors, elevators and other overhead obstacles.
- Keep your speed between 3.1-6.2 mph when you ride through speed bumps, elevator door sills, bumpy roads or other uneven surfaces. Slightly bend your knee to better adjust mentioned surfaces.
Preparations Before Use
Before riding: Wear helmets and keep knee pads in case of falls and injuries when you learn to ride the scooter
Use Guide
First Use
Step 1: Turn on the scooter, and check the power indicator.
Step 2: Step on the deck with one foot, and slowly kicks off the other on the ground.
Step 3: When the scooter starts to coast, put both feet on the deck and press the accelerator.
Step 4: Release the accelerator and squeeze the brake lever to prevent sudden braking.
Step 5: Tilt your body to the steering direction as you turn, and slowly turn the handlebar
Operation Guide
-
Turn on/ off: Long press the power button to turn the scooter on or off
-
Acceleration: When the scooter starts to coast, put both feet on the deck and press the accelerator.
-
Braking: Release the accelerator and squeeze the brake lever to prevent sudden braking.
-
Mode switching: Press the power button to switch between difterent speed modes.
Beginner mode: “S” character is displayed in blue
Normal mode: “S” character is displayed in yellow
Sport mode:”S character is displayed in red -
Turn on/ off the headlight: Double click the power button.
-
Switch (Km/h) and (Mph): Press the power button 3 times.
-
Cruise control: Maintain the current speed for 6 seconds to activate cruise mode. Disable cruise mode by pressing the accelerator or brake again
E-scooter APP
Download” iScooter “from’App Store”(iphone) or”Google Play”(Android), or scan
the QR code as below to install the App, then connect to your scooter.
Care and Maintenance
Cleaning and Maintenance
If you see stains on the scooter’s body, wipe them off with a damp cloth. If
the stains won’t scrub off, put on some toothpaste, and brush them with a
toothbrush, then wipe them off with a damp cloth.
Notes:
- Do not clean the Scooter with alcohol, gasoline, kerosene or other corrosive and volatile chemical solvents to prevent dire damage.
- Do not wash the board with a high-pressure water spray. During cleaning, make sure that the scooter’s turned off, the charging cable is unplugged, and the rubber flap is closed as water leakage may result in electric shock or other major problems. When the scooter not in use, keep it indoors where it is dry and cool.
- Do not put it outdoors for long time. Excessive sunlight, overheating and overcooling accelerate the battery pack’s lifespan.
Battery Maintenance and Disposal
- Use original battery packs, use of other models or brands may bring about safety issues.
- Do not touch the contacts. Do not dismantle or puncture the casing. Keep the contacts away from metal objects to prevent short circuits which may result in battery damage or even injuries and deaths.
- Use original power adapter to avoid potential damage or fire.
- Mishandling of used batteries may do tremendous harm to the environment. To protect natural environment, please follow local regulations to properly dispose of used batteries.
- After every use, fully charge the battery to prolong its lifespan.
Storage
- Please try to store the scooter in a cool and dry place between 14 F and 104° F. In extremely humid environments, the interior of the scooter may suffer condensation or even water accumulation, which may damage the battery rapidly. (The equipment is not designed for use at places where they are 2000m above sea level. Excessive exposure to UV rays, rain and other weather elements may damage the outer parts of the scooter)
- In daily use, try to avoid charging the scooter after completely exhausting the battery. If the battery is low, charge it as soon as possible.
- Please charge the scooter every other month to preserve the battery.