RYOBI A73TS01 55 Inch Accessory Track User Guide

: June 3, 2024
: RYOBI

Table of Contents

RYOBI A73TS01 55 Inch Accessory Track
INCLUDES
ASSEMBLING TRACKS
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

RYOBI A73TS01 55 Inch Accessory Track

For use with RYOBI PTS01 Track Saw

WARNING!
To reduce the risk of injury, user must read and understand the operator’s manual for their track saw and this instruction sheet. Always wear eye protection with side shields marked to comply with ANSI Z87.1. Ensure compatibility and fit before using this accessory. Do not use this accessory if a part is damaged or missing. If you are not comfortable performing any of the functions described in these instructions, take your unit to an authorized service center.

NOTE: Follow all guidelines and warnings in your track saw operator’s manual.

INCLUDES

See Figure 1.
27.5 in.Tracks (2), Connectors (4), and Wrench

A – Wrench (clé, llave)
B – Track (rail, riel)
C – Connector (connecteur, conector)

ASSEMBLING TRACKS

See Figures 2 – 4.

A – Track (rail, riel)
B – Connector (connecteur,conector)
C – Wrench (clé, llave)
D- Screw (vis, tornillo)

RYOBI A73TS01 55 Inch Accessory Track-fig4

A – Square (équerre, escuadra)
B – Wrench (clé, llave)
C – Screw (vis, tornillo)
A – Rubber cut strip (bande de caoutchouc, tira de corte de goma)

Tracks can be used individually or assembled together to fit the size of your project. Before use, all tracks should be assembled and properly aligned, and the rubber cut strip should be cut.

To assemble tracks:

Place the tracks upside down on a flat, level work space. NOTE: Two tracks are provided with the saw. One has a connector preinstalled and the other does not.
Using the track wrench, loosen the screws securing the connector to the track.
NOTE: Two wrenches are included with the saw, a small one for the track and a large one for the blade.
Align the tracks and slide the connector across the joint and into the slot of the next track. Place the connector approximately half way into each track and tighten the screws to secure one side.
NOTE: The tracks are machined to fit together tightly along the ends. However, before tightening the remaining screws, place a 12 in. or longer straight edge, carpenter’s square or level along the long edges to make sure the pieces are perfectly aligned. Skipping this step could compromise the accuracy of the saw’s performance.
Align the long ends of both tracks against the straight edge, carpenter’s square or level. Holding both pieces together, tighten the remaining screws to secure the connector. NOTE: After tightening the screws, check again with the straight edge to ensure the tracks are perfectly aligned.
Each track has a rubber cut strip running along the edge. Before cutting a workpiece using the track, the rubber cut strip must be trimmed away. Refer to “Using the Track” in the track saw operator’s manual.
Look for this accessory where you purchased this product or call 1-800-525-2579:
Track Clamp Assembly ………………………………. 089240074712