V-TAC VT-7223 Square Shaped Spotlight Holder Instruction Manual
- June 5, 2024
- V TAC
Table of Contents
WEEE Number: 80133970
INSTALLATION INSTRUCTION
MODEL: VT-7223
SPOTLIGHT FITTING
INTRODUCTION
Thank you for selecting and buying V-TAC LED SPOTLIGHT FITTING. V-TAC will serve you the best. Please read these instructions carefully before starting the installation and keep this manual handy for future reference. If you have any other queries, please contact our dealer or local vendor from whom you have purchased the product. They are trained and ready to serve you at their best.
INSTALLATION INSTRUCTIONS
- Switch off the power.
- Ensure that the void depth is a minimum of 90mm, the thickness of the ceiling is a maximum of 20mm (Picture 1)
- Cut a hole using an appropriate tool according to the cut-out. (Picture 2)
- Install the AR111 light source of the fitting. (Picture 3)
- Connect the wire of the driver to the mains (220-240V) in a correct way and put the driver into the ceiling properly. (Picture 4)
- Push the spring clips upwards and fit into the ceiling hole (picture 5), ensuring the product is sitting properly in the hole.
- Switch on the power if the above steps are done properly without any mistakes.
WARRANTY
- This product is warranted from manufacturing defects only.
- The warranty is valid for 2 years from the date of purchase.
- The warranty does not apply to damage caused by incorrect installation or abnormal wear and tear.
- The company gives no warranty against damage to any surface due to incorrect removal and installation of the product
INTRODUCTION & WARRANTY
Thank you for selecting and buying the V-TAC product. V-TAC will serve you the
best. Please read these instructions carefully before starting the
installation and keep this manual handy for future reference. If you have any
other queries, please contact our dealer or local vendor from whom you have
purchased the product. They are trained and ready to serve you at their best.
The warranty is valid for 2 years from the date of purchase. The warranty does
not apply to damage caused by incorrect installation or abnormal wear and
tear. The company gives no warranty against damage to any surface due to
incorrect removal and installation of the product. This product is warranted
for manufacturing defects only.
INSTALLATION INSTRUCTION
- Switch off the power
- Ensure that the void depth is a minimum of 90mm, and the thickness of the ceiling is a maximum of 20mm. (Image 1)
- Cut a hole using an appropriate tool according to the cut-out. (Image 2)
- Install the AR111 light source on the fitting. (Image 3)
- Connect the wire of the driver to the mains(220-240V) in a correct way and put the driver into the ceiling properly. (Image 4)
- Push the spring clips upwards and fit them into the ceiling hole. (Image 5). Ensure the product is sitting properly in the hole.
- Switch on the power if the above steps are done properly without any mistakes.
In case of any query /issue with the product please reach out to us at
support@vtacexports.com
In case of any query/issue with the product, please reach out to us at:
support@v-tac.eu
For More products range, inquiry please contact our distributor or nearest
dealers.
V-TAC EUROPE LTD
Bulgaria, Plovdiv 4000,
bul.L.Karavelow 9B
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>