LUXPRO LP1200V2 High-Output Large Flashlight User Manual
- June 5, 2024
- LUXPRO
Table of Contents
LUXPRO LP1200V2 High-Output Large Flashlight
Features
- Constructed with aircraft-grade aluminum
- Long range LPE optics
- Patented TackGrip rubber grip Ergonomic side button
- IPX4 waterproof rating
- Uses 6 AA or 3 AA batteries (6 AA included)
ANSI/PLATO FL1 STANDARD
Operation Instructions
Cycle Modes: Press button on side of the light quickly to cycle through
modes (High/Medium/Low). If light remains in a single mode for longer to 3-5
seconds, the next press of the button will turn the light off. Light
automatically resets to High mode when turned off.
Hidden Strobe On/Off: Press and hold button for 3 seconds to activate
hidden strobe. Flashlight will remain in hidden strobe mode until it is
deactivated by pushing and holding the button for 3 seconds again.
Battery Replacement
The LP1200V2 can use 6 or 3 AA batteries. To replace the batteries, turn the tail cap counterclockwise to remove it. Tip the light downward to slide the batteries out of the tubes.
To use the light with 6 batteries, insert 3 batteries into each tube (+) side first (batteries will stick out of the opening slightly).
To use the light with 3 batteries, insert 3 batteries into just one of the tubes (+) side first.
For best results, we recommend using brand new alkaline batteries that are the same voltage and brand. Re-attach the tail cap by pressing down and turning it clockwise until tight. If you know it will be a while between uses, we suggest removing the batteries from the flashlight and storing it in a dry, protected place.
Product Warranty
The LP1200V2 has a Limited Lifetime Warranty Against Manufacturer’s Defects from time of purchase. For warranty claims please contact us by calling 801-553-8886 or sending an email to [email protected]