monbebe SW009 Tranquility Swing User Guide

monbebe SW009 Tranquility Swing

Tranquility Swing
SW009 User Guide

Read all instructions before assembly and use.
Keep instructions for future use.

• Input Voltage: AC100-240 V
• Output Voltage: DC 6 V
• Output Current: 1 A
• Frequency: 50/60 HZ
• Ages: Children up to a weight of 25 lbs or unable to sit up unaided.
• Tools needed: Phillips head screwdriver (not included).
• Requires 4 “AAA” (1.5 V) batteries (not included).
•  Adult assembly required.

WARNING

Failure to follow these warnings and the assembly instructions could result in injury or death. Before each use and assembly, inspect swing for damaged hardware, loose joints, missing parts or sharp edges. DO NOT use swing if any parts are missing or broken. Contact Dorel Juvenile Group, Inc. for replacement parts and instructional literature if needed. DO NOT use any replacement parts not provided by Dorel Juvenile Group. DO NOT substitute parts or try to modify the product in any way. Parts not provided and approved by Dorel Juvenile Group may result in an unsafe product.

• CAUTION: Changes and Modifications not expressly approved by Dorel Juvenile Group Inc. or registrant of this equipment can void your authority to operate this equipment under Federal Communications Commission’s rules.
• CAUTION: Keep small parts away from children during assembly.

WARNING

FALL and STRANGULATION HAZARDS: Infants have suffered head injuries falling from swings and have strangled in straps.

• ALWAYS use restraints. Adjust to fit snugly.

• STOP using product when infant attempts to climb out (approximately 9 months).

• ALWAYS place swing on floor. Never use on any elevated surface.

• Stay near and watch infant during use. This product is not safe for sleep or unsupervised use. If baby falls asleep, remove baby and place in a crib, bassinet, play yard, or bedside sleeper.

• SUFFOCATION HAZARD:
  Young infants have limited head and neck control. If the seat is too upright, infant’s head can drop forward and compress the airway.

• NEVER lift or carry infant in swing.

• The toys are intended for visual stimulation and are not intended to be grasped by the infant.

• Remove toys when infant can grasp them.

• Assure toys are attached securely to product according to the instructions. Check frequently.

• DO NOT add additional strings or straps to attach the toys to the swing.

• Canopy is a possible entanglement injury. Keep out of baby’s reach. Remove canopy when infant can grasp toys.

Parts List

1. Canopy
2. Seat frame
3. Base bracket
4. Remote control
5. Adapter

Required

• Philip’s head screwdriver (not included)
• AAA” batteries (x4) (not included)
• CR2025 3V (x1) battery (included)

Keep These Instructions for Future Use

• Adult assembly required.
• Lay out and identify all parts.
• Remove all contents from packaging and discard box, and/or poly bags.
• Do not return this product to the place of purchase. If any parts are missing, call Consumer Care at 800-544-1108. Or visit our website at www.monbebe-us.com.
• Include the model number (SW009) and manufacture date (found on the bottom of the swing base) and a brief description of the part.

Assembling Your Swing

Installing the seat to the base bracket

To assemble: Align seat post on bottom of frame with the “O” shape component on base bracket.
Insert seat post into opening on base bracket. You will hear a “click”.
Pull up gently to ensure seat frame is secured to base bracket.
To disassemble : Press button and pull up on seat frame to remove from base bracket.

Installing the Canopy

• To install: Attach the clamp to the right location of the frame on both sides.
• To remove: Pull the clamps out on both sides to release the canopy.

WARNING

NEVER grab the canopy of swing to lift or carry infant.

Using Your Swing

Using Pillow

Installation:
Attach the pillow to the retaining ring at the top of the seat frame and press the hook and loop fastener on the pillow strap.
Removing:
Pull the hook and loop fastener from the pillow strap and remove the pillow.

Motion Lock / Unlock

• To lock seat frame and stop movement, push the lock to the right.
• To unlock seat frame and allow movement, push the lock to the left.

Using Restraint Straps

WARNING

• NEVER LEAVE THE CHILD UNATTENDED. ALWAYS keep the child in view when in swing.

• AVOID SERIOUS INJURY from falling or sliding out. ALWAYS use seat belt. Check frequently to make sure it is secure.

• Belts must be threaded exactly as shown (Figure d).

• Failure to follow these instructions could result in the serious injury or death of your child.

  1. Pull up on the harness buckle cover to open.

  2. Press the center button on the crotch buckle while pulling the waist buckle tongues out of the crotch buckle.

  3. Place your child in the swing, with the crotch strap between the child’s legs. Fasten both buckles.

  4. Tighten waist and shoulder straps snugly around your child.

  5. Shoulder straps: To tighten Push up on the lower strap at (A), feed through the adjuster and pull up on upper strap to remove slack (Figure e).
     To loosen
     Push down on upper strap at (B), feed through adjuster and pull down on lower strap to remove slack (Figure e).

  6. Waist straps:
     To tighten
     Push up on lower strap at (C), feed through adjuster and pull up on upper strap to remove slack (Figure f).

  7. To loosen
     Push down on upper strap at (D), feed through adjuster and pull down on lower strap to remove slack (Figure g).

using the control panel

• Power: Plug AC adapter into swing and wall outlet, or use battery power.
• Press power button to start the swing.
• You will see the indicator light illuminate.
• Press the power button once more to turn swing  off.
• Music button : Press the button to play the built in

continuous music.

• Press it again to turn the sound off.
• Music Button: Press button to play the next song.
• Volume Up: Press button to increase the volume gradually.
• Volume Down : Press button to decrease the volume gradually.
• Speed Settings: Press this button to adjust the swing speeds. There are five speeds with indicator lights. The default timer is set to 15 minutes.
• The swing angle adjusts automatically with each speed setting.
  • Speed 1 = Swing angle 8° to 12°
  • Speed 2 = Swing angle 12° to 16°
  • Speed 3 = Swing angle 16° to 20°
  • Speed 4 = Swing angle 20° to 24°
  • Speed 5 = Swing angle 24° to 28°
• Timer: Press button to set the swing timer. There are 3 different settings.
  • 1x = approximately 15 minutes swing time
  • 2x = approximately 30 minutes swing time
  • 3x = approximately 45 minutes swing time Small indicator lights show the time. The default setting is 15 minutes when the machine is turned on.

Remote Control Battery Installation

WARNING

This product contains button or coin cell batteries. A swallowed button or coin cell battery can cause internal chemical burns in as little as two hours and lead to death. Dispose of used batteries immediately. Keep new and used batteries away from children. If you think batteries may have been swallowed or placed inside any part of the body, seek immediate medical attention.To remove battery, press flexible tab and slide battery compartment open.

Remove battery. Discard battery properly.
Button cell size: CR2025 3V (x1) LITHIUM BATTERY.

Using Remote Control

• Power on/off
  • Time setting:
  • Press 1x: 15min
  • Press 2x: 30min
  • Press 3x: 35min
  • Repeat steps for cycle changing.
• Built-in music/Bluetooth music:
  • Press:
  • Press the Blue/Music button to play built-in songs.
  • Press and hold the Blue/Music button to activate blue tooth model.
  • Once the Bluetooth mode is active, use your cell phone to search the Bluetooth and then use it.
  • Volume up
  • Volume down
  • play/pause: just for pre-recorded songs
  • Previous song: just for pre-recorded songs
  • Next song: just for pre-recorded songs
  • Five swing speed buttons Stop swing: Press this button to stop swing.
  • To resume swing, press any of the 5 speed buttons.

Using Your Swing

1. DC plug can be inserted into 100-240V~ 50/60Hz AC power supply.
2. Adapter output parameters: voltage is 5V and current is 1A.

WARNING

STRANGULATION HAZARD

• Children have STRANGLED in cords.
• • Keep this cord out of the reach of children.
•  DO NOT remove this tag.

Battery Installation

1. Locate battery compartment door on bottom of base bracket (Figure a).
2. Using a Phillip’s head screwdriver, unscrew the battery cover and remove (Figure b).
3. Install 4 “AAA” alkaline batteries. Place battery cover back and screw it tightly (Figure c).

BATTERY CAUTION

• Keep these instructions as they contain important information
• We recommend alkaline batteries for longer battery life.
• DO NOT mix old and new batteries.
• DO NOT mix alkaline, standard (carbon zinc), or rechargeable (nickel cadmium) batteries.
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the unit before being charged.
• Rechargeable batteries are only to be charged under adult supervision.
• Only batteries of the same or equivalent type as recommended are to be used.
• Batteries are to be inserted with the correct polarity.
• Exhausted batteries are to be removed from the unit.
• The supply terminals are not to be short-circuited.
• Check that all contact surfaces are clean and bright before installing batteries
• DO NOT submerge any part of the product in water.
• Dispose of batteries safely.
• Remove batteries when stored for long periods of non-use.

CAUTION

To prevent battery leaks, which can burn skin and eyes:

• Always replace the entire set of batteries at one time.
• Never mix old and new batteries, or batteries of different brands or types.
• Remove batteries when storing product for a long time.
• Dispose of used batteries immediately.
• Use only AAA(1.5V) batteries.

FCC Information

CAUTION: The user is cautioned that changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Wash and Care

• Base bracket & seat frame: Clean with wet cloth and a mild detergent. Dry thoroughly. DO NOT use corrosive cleaners.
• Seat fabric: Clean with wet cloth and a mild detergent. Air dry.
• Canopy: Remove it and hand wash with mild detergent. Rinse with clean water. Air dry. Avoid sun exposure.
• Pillow: Pull the hook and loop fastener off and remove the pillow. Hand wash with mild detergent. Rinse with clean water. Air dry. Avoid sun exposure.

Maintenance

1. Please check this baby swing regularly. Make sure each part is well connected and well installed. Stop using for poor connection and connect/install it again if necessary.
2. This product contains electronic components, which shall not be used in water or in a humid environment. Please ensure the pro-duct is dry, and store it in a cool and dry place, avoiding direct sunshine for a long time.

Troubleshooting

Replacement Parts

• Canopy
• Adapter
• To order parts call 800-544-1108. Include the model number (SW009) and manufacture date (found on the bottom of the swing base) and a brief description of the part.

One (1) Year Limited Warranty

Dorel Juvenile Group, Inc. warrants to the original pur-chaser that this product (Tranquility Swing) is free from material and workmanship defects when used under normal conditions for a period of one (1) year from the date of purchase. Should the product contain defects in material or workmanship Dorel Juvenile Group, Inc., will repair or replace the product, at our option, free of charge.
Purchaser will be responsible for all costs associated with packaging and shipping the product to Dorel Juvenile Group Consumer Care Department at the address noted on front page and all other freight or insurance costs associated with the return.
Dorel Juvenile Group will bear the cost of shipping the repaired or replaced product to the purchaser. Product should be returned in its original package accompanied by a proof of purchase, either a sales receipt or other proof that the product is within the warranty period.
This warranty is void if the owner repairs or modifies the product or the product has been damaged as a result of misuse. This warranty excludes any liability other than that expressly stated previously, including but not limited to, any incidental or inconsequential damages.
SOME STATES DO NOT ALLOW THE EX-CLUSION OR LIMITATION OF INCIDEN-TAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT APPLY TO YOU.
THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY ALSO HAVE OTHER RIGHTS THAT MAY VARY FROM STATE TO STATE.

Documents / Resources

| monbebe SW009 Tranquility Swing [pdf] User Guide
SW009, 2A3C8-SW009, 2A3C8SW009, SW009 Tranquility Swing, SW009, Tranquility Swing
---|---

References

• Home (2021) - Monbebe | Dorel Industries

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>