doorKNOX VDP103 Keypad Video Door Entry Camera User Guide
- June 5, 2024
- doorKNOX
Table of Contents
DoorKnox Keypad Video Door Entry Camera
Doorknox is a registered trademark of System Q Ltd
VDP103 – Quick Start Guide
Scan QR Code for Full Manual
https://www.systemq.com/PDF/manual/xVDP103.pdf
VDP103s from serial number HBY00401 onwards have new firmware that is set up and programmed from the keypad. Prior to this serial number, the VDP103 required access to the back of the unit to add cards or PIN numbers.
The VDP103 needs to be powered from the 2.1mm DC Socket with a local 12V DC power supply as well as the connections going back to the monitor.
When mounting the door entry camera it is recommended to be installed between
150 to 160cm above the floor (About 5 feet) it should not be mounted in direct
sunlight.
When recess mounting the camera creates a recess of 200mm (h) x 96mm (w) x
29mm (d).
It is important that the recess created is no more than 30mm deep otherwise
the securing screws cannot be accessed.
Default Settings
Admin PIN – 999999
Entry Pin – No Default
Unlock Mode – Card or PIN
Unlock Time – 2s
Safe Mode – Off
Entering Admin Mode
Press *(Admin PIN )# the VDP103 will beep 2 twice and the light behind the
name panel will flash slowly.
If an incorrect PIN is entered the VDP103 will beep 4 times.
For security reasons, it is best to change the Admin PIN during installation.
Adding an Entry PIN
Adding an Entry Pin will allow access regardless of the unlock mode that the
VDP is set to.
In admin mode:Press 011#nnnnnn# (single beep) nnnnnn# (double beep)
Note: nnnnn n = new 6 digit PIN.
To release an electronic door using a PIN, simply enter the PIN followed by
the ‘#’ key. You will hear two short beeps if the PIN is correct, otherwise,
you will hear four short beeps.
For programming fobs or cards see the full manual
| Model | VDP103 |
|---|---|
| Image Sensor | 1/3″ CMOS |
| Resolution | 800TVL |
| Lens Type | 3.6mm Board / 85° Viewing Angle |
| Input Voltage | 12V DC |
| Current Consumption | 300mA (12V DC 1 A PSU Supplied) |
| Build | (H) 210 x (W) 105 x (D) 32mm |
| Cards or Fobs Qty | 200 |
| RFID Frequency | 13.56 MHZ |
All specifications are approximate. System Q Ltd reserves the right to change product specifications or features without notice. Whilst every effort is made to ensure that these instructions are complete and accurate, System Q Ltd cannot be held responsible for any losses, no matter how they arise, from errors or omissions in these instructions, or the performance or non- performance of the equipment refered to.
This symbol indicates that equipment must not be mixed with general household
waste.
For treatment, recovery, and recycling please return to your local designated
WEE/CG0783SS collection point as defined by your local council.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>