Mytee S-300H Tempo Heated Carpet and Upholstery Extractor User Manual

: June 5, 2024
: MYTEE

Mytee S-300H Tempo Heated Carpet and Upholstery

 **Extractor User Manual**

Mytee S-300H Tempo Heated Carpet and Upholstery Extractor User
Manual

13655 Stowe Dr. Poway, CA 92064
P: 858-679-1191
F: 858-726-6005
www.mytee.com

Introduction

Dear Customer:

Congratulations on the purchase of your new Tempo™ Upholstery Spotter. As technology continues to develop you can work confidently knowing that both Mytee and its employees are equally dedicated to developing with the industry and its advances.
Like any other piece of machinery or technology, the Tempo™ also requires the proper maintenance and care to keep the product working over extended use. Neglecting your machine, abusing it or not operating it properly can void its warranty and prevent the machine from performing to the quality and standard you’d expect out of the Mytee line.
If you have any warranty concerns or questions, please review this manual thoroughly or do not hesitate to contact your distributor. If there are questions regarding maintenance, replacement, or ordering parts please contact an authorized Mytee Service Center.
Before using your Mytee product, please read this manual thoroughly.

Sincerely,
Mytee Customer Care Dept.

Important Safety Information

Grounding Instructions

This machine must be grounded. If it should malfunction or breakdown, grounding provides a path of least resistance for electrical shock. This machine is equipped with a cord having an equipment-grounding conductor and grounding plug. The plug must be plugged into an appropriate outlet that is properly installed in accordance with all local code and ordinances. Do not remove ground pin; if missing, replace plug before use.

Improper installation of the equipment-grounding conductor can result in a risk of electric shock. Be sure to check with a qualified electrician or service person if you are in doubt as to whether the outlet is properly grounded. If the plug will not fit in the outlet do not modify either the plug nor the machine’s cord, instead have a proper outlet installed by a qualified technician.

This machine is for use on a nominal 120-volt circuit and with a grounding plug similar to the one in Figure 1 below. If a proper outlet is not available, follow the illustrations of Figure 2 & 3 to install a temporary- grounding plug. This temporary work-around should be used only until a proper outlet (Figure 1) can be installed by a qualified electrician. When and if this type of adapter is employed, screw the adapter’s extended tab into place with a metal screw. However, grounding adapters are not approved for use in Canada.

Again, be sure to check the grounding pin for damages and replace if necessary.

The Green, or Green-Yellow, wire in the cord is the grounding wire. When replacing a plug, this wire must be attached to only the grounding pin.

DO NOT use extension cords.

Please Note for America use only.

Mytee S-300H Tempo Heated Carpet and Upholstery Extractor - figure
1,2,3

Parts and Service

Please contact a Mytee service personnel or Mytee authorized Service Center using Mytee original replacement parts and accessories for repairs are needing to be performed. When and if calling Mytee for support, please have your Model and Serial Number available for faster assistance.

Name Plate

The Model and Serial Number are located on the lower half of the back of the machine near the power plugs and will be required for ordering replacement parts. You can use the space provided on the front of this manual to note down both for future referencing.

Unpacking the Machine

When your new machine is delivered, please carefully inspect both the shipping carton and the machine for damages. If damage is evident, save both the shipping carton and machine so that the delivering carrier can inspect it. Contact the carrier immediately to file a freight claim if there has been any damage.

Caution and Warnings

Symbols

Mytee uses the symbols below to signal potentially dangerous conditions. Always read this information carefully and take the necessary steps to protect personnel and property

Is used to warn of immediate hazards that will cause severe personal injury or death.

Is used to call attention to a situation that could cause severe personal injury

Is used to call attention to a situation that could cause minor personal injury or damage to the machine or other property. When using an electrical appliance, basic precautions should always be followed, including the following: Read all instructions before using this machine. This product is intended for commercial use only.

To reduce the risk of fire, electrical shock, or injury:

Read all instructions before using equipment.
Use only as described in this manual. Use only manufacturer’s recommended attachments.
Always unplug power cord from electrical outlet before attempting any adjustments or repairs.
Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
Do not pull or carry by cord. Do not close a door on cord or pull cord around sharp edges or corners.
Do not run appliance over cord. Keep cord away from heated surfaces.
Do not use with damaged cord or plug. If cord is damaged, repair immediately.
Do not use outdoors or on wet surfaces and or standing water.
Always unplug or disconnect the appliance from power supply when not in use.
Do not allow to be used as a toy. Close attention is necessary when used by or near children.
Do not use in areas where flammable or combustible material may be present.
Do not leave the unit exposed to harsh weather elements. Temperatures below freezing may damage components and void warranty.
Use only the appropriate handles to move and lift unit. Do not use any other parts of this machine for this purpose.
Do not pull on hoses in order to move the unit. Only use the appropriate handles.
Keep hair, loose clothing, fingers, and all parts of the body away from all openings and moving parts.
Use extra care when using on stairs.
To reduce the risk of fire or electric shock, do not use this machine with a solid-state speed control device.
The voltage and frequency indicated on the name plate must correspond to the wall receptacle supply voltage.
When cleaning and servicing the machine, local or national regulations may apply to the safe disposal of liquids which may contain: chemicals, grease, oil, acid, alkalines, or other dangerous liquids.
Do not leave operating unattended.

At a Glance

1.1 – Technical Specifications

S-300 Tempo™

Mytee S-300H Tempo Heated Carpet and Upholstery Extractor - S-300
Tempo

S-300H Tempo™ w/ Heat

Mytee S-300H Tempo Heated Carpet and Upholstery Extractor - S-300H Tempo w
Heat

1.2 – Included with the Tempo™

8400P-8 Air Lite™ Upholstery Tool and 8’ Vacuum and Solution Hose Combo

G079 Heatguard™ Hose Wrap

1.3 – Tempo™ Front View

Mytee S-300H Tempo Heated Carpet and Upholstery Extractor - Tempo™ Front
View

Barbed vacuum hose connection
Recovery tank
Solution tank fill opening
Switch plate
25’ power cord
Quick connect fitting
Solution tank
Recovery tank lid

1.4 – Tempo™ Rear View

Mytee S-300H Tempo Heated Carpet and Upholstery Extractor - Tempo Rear
View

Carrying handle
Recovery tank drain cap
3” swivel casters

1.5 – Switch Plate

Mytee S-300H Tempo Heated Carpet and Upholstery Extractor - Switch
Plate

Vacuum Switch
Activates the vacuum motor.
Pump Switch
Activates the solution pump.
Heater Switch
Activates the heater.

Machine Operation

2.1 – Powering the Tempo™

To power the Tempo™, plug the power cord into a 20 amp wall outlet. ♦

2.2 – Connecting Hoses & Cleaning Tools

The Tempo™ features a 1 1/4” barbed vacuum hose connection as well as a standard 1/4” quick disconnect fitting for solution hoses. ♦

2.3 – Filling the Solution Tank

The Tempo™ solution tank can be filled up from a pitcher or other water container via the opening.

IMPORTANT: Use only low foam or non foaming detergent or shampoo. Damage due to excessive foam will void warranty. ♦

2.4 – Switching on the Tempo™

S-300 Tempo™

After a cleaning tool is connected and the solution tank is filled, switch on the vacuum and the pump in any order.

S-300H Tempo™ w/ Heat

In order to avoid vapor locking the unit, the Tempo’s™ components should be switched on by following the procedure below:

Turn pump switch on.
Pull the lever on the cleaning tool to release air in the line. Hold lever until a steady flow of water comes out of the wand.
Once pump is primed and there is pressure in the solution line, turn on heater switch and wait a few minutes for water to heat up.
Once water is heated, turn on vacuum and begin cleaning.

Note : When cleaning upholstery, always check manufacturer’s cleaning instructions. ♦

2.5 – Cleaning with the Tempo™

For best results when extracting, do one wet pass followed by two dry passes. This ensures you’re not over-soaking the material and also gives the heater time to catch up. ♦

2.6 – Emptying the Recovery Tank

The recovery tank drain is located on the back of the machine at the bottom of the recovery tank. ♦

Machine Maintenance

In order to keep the Tempo™ running smoothly and reduce the risk of damage to the machine and subsequent downtime, Mytee recommends following the maintenance schedule below:

Mytee S-300H Tempo Heated Carpet and Upholstery Extractor - Machine
Maintenance

3.1 – Filter Maintenance

The Tempo™ has a small filter on the top of the vacuum stack in the recovery tank. This filter should be checked and cleaned after each use. ♦

3.2 – System Maintainer

Regular flushing of the solution system with Mytee® System Maintainer helps keep lines clean and prevents chemical build-up, improving pump life, performance and pressure.

How to use System Maintainer: