iTECH WORLD 1000W Pure Sine Wave Inverter Remote Control RC1 User Guide
- June 5, 2024
- iTECH WORLD
Table of Contents
iTECH WORLD 1000W Pure Sine Wave Inverter Remote Control RC1
Introduction
Thank you for purchasing the Techworld pure sine wave inverter remote control
(RC1). This remote control will allow you to turn your inverter on/off from a
distance. The remote control (RC1) also allows you to monitor your battery
capacity, DC power input, the load being drawn from your inverter and AC
output.
| A | Remote Control Main Switch |
|---|---|
| B | Fault LED Indicator |
| C | AC Output Indicator |
| D | Inverter Load Indicator |
| E | DC Input Power Indicator |
| F | Battery Capacity Indicator |
-
A. Remote Control Main Switch
The main switch is used for turning ON or OFF the output of the inverter. With the switch in the ON position, the AC Output Indicator LED(C) will glow green to indicate 240VAC is being produced. -
B. Fault LED Indicator
Will illuminate/flash red when a fault is detected, the 240VAC output will be turned off. Please refer to the troubleshooting section. -
C. AC Output Indicator
Will illuminate green to show that the inverter is outputting 240VAC power. -
D. Inverter Load Indicator
Displays the approximate load being drawn from the inverter. -
E. DC Power Indicator
Will illuminate green to show that DC power is being supplied to the inverter. -
F. Battery Capacity Indicator
Displays the approximate remaining capacity of the battery running that is connected to the inverter.
Connecting the remote control
The remote control is connected to the inverter with the communications cable,
supplied with the purchase of the remote control. The cable is a 6-conductor
RJ11 cable (the pinout of the connector is a Straight Pinout and NOT Reverse,
refer to the image below). The cable is connected to the RJ-11 ports found on
the rear of the remote and on the front panel of the inverter (Port F in
figures 1 and 2 of your inverter’s instruction manual).
Using the remote control
When using the remote control to turn the inverter on or off, please make sure the Main Switch on the inverter front panel is in the OFF position, or the remote-control main switch will not work.
Contact
- Techworld
- 281 Great Eastern Hwy Burswood WA 6100
- Phone:
- 1300 483 249
- Website:
- www.itechworld.com.au
- E-mail:
- service@itechworld.com.au
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>