Dongguan Feitianqi Trading BH591A True Wireless Earbuds User Manual
- June 5, 2024
- Dongguan Feitianqi Trading
Table of Contents
Dongguan Feitianqi Trading BH591A True Wireless Earbuds
PACKING LIST
DIAGRAM
POWER ON
- The earphones automatically turn on(with white LED light fiashing) and start pairing when you open the charging case.
- In the shutdown status and when the earphones are not in the charging case, simultaneously press and hold the MFB of both earbuds for 2 seconds to power on ( with the white LED tight flashing).
POWER OFF
- Put the earphones back in the charging case and close the case to turn them off.
- If the earphones are not in the charging case. just press and hold the MFB of both earbuds for 5 seconds to power them off. (Mode 2 cannot be conducted during music playing or calling.)
PAIRING
Open the charging case. they will automatically enter the pairing mode in
which the LED light flashes white and red alternately and then select “Beans
Fl·.
Note The earbud will reconnect to the paired device bf priority. want to pair
to the second smartphone. please disconnect Bluetooth on the paired
smartphone.
MUSIC
- Volume Up/ Down
- volume +: press and hold the MFB button on the Right earbud to turn up the volume increasingly.
- Volume-: press and hold the MFB button of Lef\ earbud to turn down the volume decreasingly.
- Next/ Previous Track
- Next Track: double touch the MFB of the Right earbud.
- Previous Track: double touch the MFB of the Left earbud.
- Play/ Pause
- Touch the MFB of either earbud once.
INCOMING CALL
- Answer/ Hang Up
- Double touch the MFB of either earbud.
- Reject
- Press and hold the MFB of either earbud for l second.
- Activate Siri
- Triple-touch the MFB of either earbud.
RESET
in the state of charging, simultaneously press and hold the MFB of both earbuds for s seconds. The LED light will flash red which means that the paired information is clear.
CHARGING
Do not put the earbuds in the charging case Vvhen the earbuds are ‘Net
FCC STATEMENT
Any changes or modifications not expressly approved by the party responsible
for compliance could void the use(s authority to operate the equipment
NOTE: This equipment has been tested and found too be campy with the
limits B digital device. pursuant to Part 15 of the RX Rules These limits are
designed to provide reasonable protection against harmful interference in a
residential installation This equipment generates. uses and can radiate radio
frequency end, grand, if not installed and used in accordance with the
instructions. may cause harmful interference to radio communications.
however, there is no guarantee that interference will not occur in a
particular installation If this equipment does cause harmful interference to
radio or television reception. which can be determined by turning the
equipment off and on. the user is encouraged to try to correct the
interference bf one or more of the following measures
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver.
- connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- consutt the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions (l) This device may not cause harmful interference. and (2) this deice must accept any interference received, including interference that may cause undesired operation. FCC Radiation Exposure Statement: This equipment com is with FCC radiation exposure limits set forth for an uncontrolled environment
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>