nor-tec 80060 Key Box with Code Instruction Manual
- June 5, 2024
- nor-tec
Table of Contents
KEY BOX WITH COMBINATION LOCK
Technical data
Dimensions: 115x95x43 mm.
Comes with 4 screws and 4 rawl plugs.
Components
- Wheels
- Lock button
- Sliding door
- Lock pin
- Mounting holes
Mounting
Find a suitable place for mounting either indoors or out.
Make sure there are no wires, pipes, etc. concealed in the wall.
Mark the four holes (5) in the rear of the key box on the wall.
Drill the holes, insert the rawl plugs provided and screw the key box securely
to the wall using the screws provided.
How to set/cancel the code
The code is set to 0-0-0-0 at the factory. Turn the wheels (1) to this setting
and pull the lock button (2) down to open the door. Move the lock pin (4) on
the inside of the door to the right and upward.
Turn the wheels to the number combination you want to use as the code.
Move the lock pin back to its original position. Close the door and turn the
wheels to a random number combination to lock the key box.
Turn the wheels to the set code and press the button to open the key box.
Service center
Note: Please quote the product model number in connection with all
inquiries.
The model number is shown on the front of this manual and on the product
rating plate. • www.schou.com
Manufactured in P.R.C.
Manufacturer:
Schou Company A/S
Nordager 31
DK-6000 Kolding
All rights reserved. The content of this manual may not be reproduced, either in full or in part, in any way by electronic or mechanical means, e.g. photocopying or publication, translated, or saved in an information storage and retrieval system without written permission from Schou Company NS.