nor-tec 57121 Safety Key Box Lock Instruction Manual
- June 4, 2024
- nor-tec
Table of Contents
nor-tec 57121 Safety Key Box Lock
WHAT IN BOX
Introduction
To get the most out of your new product, please read this instruction manual before use. Please also save the instructions in case you need to refer to them at a later date.
Warnings:
- The function of the product may be impaired if you do not follow the instructions for use.
- Replace the product if it is damaged, worn or defective.
Use
The product can be used on drawers and cupboards with a front thickness of up
to 25 mm.
Scan the QR code on the front of this manual to see an installation guide for
the product. Please refer to the illustrations at the front of these
instructions.
- Lock the product.
- Assemble the product as illustrated.
- Clean the installation point so that the surface is free of grease, dust and dirt. Remove the protective foil from the tape and place the product in the desired location so that the cupboard/drawer can be closed. Avoid touching the adhesive surface of the tape. Press and hold the product in place for 30 seconds. The tape achieves its maximum adhesion after 24 hours.
- Remove the frame.
- The product can also be secured in place using the supplied screws.
- Unlock the product.
- The product can be unlocked using the supplied magnetic key.
- Key storage.
Service Center
Note : Please quote the product model number in connection with all inquiries. The model number is shown on the front of this manual and on the product rating plate.
For:
- Complaints
- Replacement parts
- Returns
- Guarantee issues
- www.schou.com
Manufactured in P.R.C.
Manufacturer:
Schou Company A/S Nordager 31 DK-6000 Kolding
All rights reserved. The content of this manual may not be reproduced, either in full or in part, in any way by electronic or mechanical means, e.g. photocopying or publication, translated or saved in information storage and retrieval system without written permission from Schou Company A/S.