LIGHTMODE Night Shift Helmet Installation Guide
- June 5, 2024
- LIGHTMODE
Table of Contents
LIGHTMODE
Night Shift Helmet
Installation Guide
Night Shift Install Guide
Version 1.0
– Jan. 25, 2022
Night Shift Helmet
Step 1. Clean
Gently clean the area you will be sticking the light strips on with the
alcohol prep pad.
Step 2. Mount Controller
Clip your controller onto your LightMode mount, plug-in an LED strip, and
locate a good spot to stick your mount to. Use the provided extension wires if
needed.
Step 3. Stick Mount to Helmet
Peel off the adhesive backing on your mount and lightly stick it on your
helmet. Do not press firmly until after Step 4.
TIP
If there are gaps between your helmet and LightMode mount, cut the provided 3M
adhesive to size and fill the gaps.
Step 4. Stick Light Strips to Helmet.
Peel off a section of the backing and use it to anchor your light strip to
your helmet. Gradually peel off the backing as you lightly stick the light
strip from one side to the other.
TIP
The LED strips naturally want to follow a straight path. If you try to bend a
strip laterally, while laying it down, the edge will tend to lift. Try to
avoid this IF possible.
Try to avoid repeatedly unpeeling the LED strips to reposition. They may not
be as sticky after multiple attempts. You also run a small risk of
accidentally breaking the circuit inside the LED strip.
Step 5. Press Firmly
Once you are completely satisfied with the position of your mount and light
strips, press them firmly to your helmet.
ENJOY!
Documents / Resources
|
LIGHTMODE Night Shift
Helmet
[pdf] Installation Guide
Night Shift, Helmet, Night Shift Helmet
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>