XCHENG TECH T5 Mobile Phone User Guide
- June 5, 2024
- XCHENG TECH
Table of Contents
T5
Quick Guide
PRODUCT INTRODUCTION
Power Button
Short Press: Light the screen, lock the screen.
Long press: In shutdown state, long press 2-3 seconds to turn on; When in use,
press 2-3 seconds for a long time, and you can choose to Power off, Restart,
or Screenshot.
In the crash state, long press 10 seconds to restart automatically.
Left and right scan button
Open the scan code app, short press the scan button to achieve the scan code
function.
Scanner
Scanning recognition of Barcode and QRcode can be carried out by using
scanning dock when scanning function is turned on.
Extend pins
To connect to dock. (Need to buy dock separately)
Type-C USB
Used For device charging, and you can also plug in OTG.
Headphone
Insert a wired headset, and the sound will be switched from the speaker to the
headset.
MIC
Used to make phone calls, video, and voice conversations.
Speaker
Used For listening to music or sound amplification.
Receiver
Used to make calls to receive sound.
Indicator Light
Android Charging and Notification Indicator Lamp (Breathing Lamp) ( Red,
Green).
SD card slot and two Nano SIM card slot
Used for inserting the SIM Card and SD Card slot.
Rear camera and Front camera
Supports photographing and 1D/2D code quick scanning.
TECHNICAL INDICATORS OF PRODUCTS
- Android 10
- Quad core 1.8GHz
- LTE/UMTS/GSM/WIFI 2.4&5G/Bluetooth
- 2GB RAM, 16GB ROM
- LCD/CTP：4.0WVGA
- Scanner: E3
- Bluetooth 5.0
- Rear camera：8M AF ，Front camera：2M FF
- Wi-Fi 802.11a/b/g/n（2.4G/5G）
- USB Type-C
- Battery 3.85V/4500mAh
ATTENTION
PRODUCT SAFETY WARNINGS
Use responsibly. Read all instructions and safety information before use to
avoid injury. The limit operating ambient temperature of the equipment
declared by the manufacturers-15~55°C.
Battery Safety
Charge battery only at ambient temperatures ranging from 40°C.
- CAUTION: Danger of explosion if the battery is incorrectly replaced. Replace only with the same or equivalent type of battery recommended by the manufacturer. Dispose of used batteries according to the battery manufacturer’s instructions.
- CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
- CAUTION: Battery charging temperature upper limit is 40°C.
Adapter Safety
When charging, please place the device in an environment that has a normal
room temperature and good ventilation. It is recommended to charge the device
in an environment with a temperature that ranges from 0°C~40°C.For altitude
2km below use only.
Wi-Fi Safety
Turn Wi-Fi off in areas where Wi-Fi use is prohibited or when it may cause
interference or danger, such as in airplanes while flying.
SAR compliance for body-worn operation is based on a separation distance of 15
mm between the unit and the human body. Carry this device at least 15 mm away
from your body to ensure RF exposure level compliant or lower than the
reported level.
To support body-worn operation, choose the belt clips or holsters, which do
not contain metallic components, to maintain a separation of 15 mm between
this device and your body.
To support body-worn operation, choose the belt clips or holsters, which do
not contain metallic components, to maintain a separation of 15 mm between
this device and your body.
Caution: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
FCC Regulations:
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.
Radio Frequency (RF) Energy
This device is designed and manufactured not to exceed the emission limits for
exposure to radio frequency (RF) energy set by ` the Federal Communications
Commission of the United States.
The exposure standard for wireless devices employing a unit of measurement is
known as the Specific Absorption Rate, or SAR. The SAR limit recommended by
the general public is 1.6W/kg. Averaged over one gram of tissue by IEEE Std
1528.
While there may be differences between the SAR levels of various product and
at various positions, they all meet the government requirements.
Development size：140110mm
Folding size：70110mm
The tolerance：+/-1mm