EKOBOR E10101-ES02 I-Standing Desk Single Motor User Manual
- June 5, 2024
- EKOBOR
Table of Contents
E10101-ES02 I-Standing Desk Single Motor
User Manual
Touch Button Instruction
Reset Operation (RST)
Press the DOWN button for 30-40 seconds, kindly ensure no obstacles underneath the desk, and continue to descend until it shows the lowest height which is 75cm.
Memory Function
To use the memory positions, set the desk to the desired height press “S,” AND THEN PRESS 1, 2, 3, OR 4. The correct height will then be stored to the corresponding number.
Lock & Unlock Operation
Lock： hold touch“S”+“︿” for 5s, indicator show “LOC”, this means the system
has been locked, and can not do any operation.
Unlock： hold touch“S”+“﹀” for 5s, when the indicator shows “LOC” change to a
normal figure, this means the system is unlocked.
“HOT”-Overheat
If the indicator shows HOT, it means the system is overheating or continuously working for over 2 minutes. It should wait 18mins for the rest until the digital shows the height figure.
Height limit
Keep pressing “﹀”+“︿” for 5 seconds， it can set the height limit position.
It can be canceled with the same method.
Reminder time to stand and sit!
Keep pressing “1+3” for 5 seconds and it shows “0.0h,” press the “up” button to change the time, press one time is 0.5h (30 minutes), press twice is 1.0h (60 minutes), when the time is over, it will appear a beep tone.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>