SONICWARE ELZ-1 V5 Portable Synthesizer Instruction Manual

: June 5, 2024
: SONICWARE

Table of Contents

About this manual
Added Effects
Added MASTER Effects
Added DUAL MONO Mode
Documents / Resources

SONICWARE ELZ-1 V5 Portable Synthesizer

About this manual

This manual explains features added in the Version 5 SYSTEM firmware.

Added Effects

DRIVE/MOD module

CRUSHER
PRM1| BALANCE| 0~100
PRM2| BIT CRUSH| Off, 8bit, 4bit, 2bit
PRM3| FREQUENCY| 1~100
PRM4| FINE| 0~20
DELAY/REVERB module

REVERS
PRM1| MIX| 0~127
PRM2| DECAY| 0~127
PRM3| –| –
PRM4| –| –

Added MASTER Effects

REVERB/MASTER module

[HINT]

In the AUX IN menu, there is an option for EFX SEND, which allows you to choose how much of the AUX signal is sent thought the ELZ_1 ‘.s effects, and how much is sent directly the ELZ_l ‘.s output. In other words, this is the AUX inputs “Ory/Wet” control for the ELZ_l ‘.s effects.
For the VINYL RECORD, CASSETTE TAPE, and CRUSHER effects, the EFX SEND control has only two settings, 100% of the signal going through the effects, or completely bypassing the effects and going straight to the output.

Added DUAL MONO Mode

It is now possible to send two separate mono signals into the AUX input for FX processing and mixing.
To achieve this, you must use a 1/8″ (3.5 mm) stereo to Left/Right dual mono adapter.

① Press the MENU button.
② Use the DOWN and UP buttons or turn any knob to select AUXIN , and press the OK button.
③ Use the DOWN and UP buttons or turn any knob to select AUXIN MODE, and press the OK button.
④ Use the DOWN and UP buttons or turn any knob to select Dual Mono, and press the OK button.

[HINT]

When Dual Mono mode is selected, additional options will appear in the AUX IN menu. These include the following setting for independently adjusting the mono channels: