WellO2 WE-BT-01 Breathing Trainer User Guide

WellO2 WE-BT-01 Breathing Trainer

Included with the WellO2 Inhaler

Before using for the first time, we recommend that you run the cleaning

program

1. Fill with cold tap water to the level between min-max.
   

2. Put the cleaning basket back in the appliance.

3. Set the appliance on the base.

4. Press the button for the cleaning program for about 3 seconds. Wait for the beep and the button will start flashing.

5. The cleaning program lasts for about 20 minutes and ends with a signal.

6. Pour out the water when it has cooled down.

7. Disassemble the parts, rinse, and allow to drip dry. Instructions for disassembling the parts can be found on the last page.
   

Assembly before use

1. Align the arrow-shaped edge of the respirator against the corresponding bulge of the lid and slide the parts together.
   

2. Cleaning basket and lid are assembled together that the basket brackets hook into the opening on the sides of the lid.

3. Attach the nozzle to the respirator.

4. Attach the extension hose to the nozzle when using the nasal mask.
   

Breathing Exercises

General Instructions

• Always use clean and cold tap water.
• Do not leave water in the appliance after use.
• We recommend that you do the first breathing exercise regularly during the first month, preferably 1-2 times / day. After that, you can reduce to a few times per week but still regularly.
• The purpose of WellO2 breathing exercises is to do continuous inhaling and exhaling. If the workout feels too heavy, you can breathe freely between breaths with resistance.

Start with the breathing exercises

1. Select the desired temperature. * Wait for the audible signal and a steady light.

2. Select the lowest resistance (0).

3. Take a deep breath and exhale through the mouthpiece until you have emptied your lungs.

4. Take a few regular breaths and repeat the exhalation through the mouthpiece.

5. Take a gentle breath through the mouthpiece until you have filled your lungs. Hold your breath for 1-3 seconds before breathing out.

6. Repeat the inhalations through the mouthpiece 5-15 times or the number that suits you best. You can breathe as usual between repetitions.

! Maintain good posture throughout the breathing exercise

When using a nasal mask:

• Always use the lowest breathing resistance when inhaling with the nasal mask
• Always start with the lowest temperature

1. Blow through the extension hose to achieve more steam.

2. Assemble the mask / hose and put the mask over the nose. Inhale the vapor through your nose for a full breath.
   

3. Breath freely a few times.

4. Repeat steps 1 and 2 as needed.
   
   You can increase the number of repetitions to 10-15 times once you get used to the nose mask.

Disassemble the parts after use.

1. Turn/remove the lid/basket from main unit.
2. Remove the nozzle.
3. Follow the instructions below to disassemble the lid and the cleaning basket.

Detach the lid from the cleaning basket:

1. Grasp the lid with one hand and the basket with the other.

2. Press your thumb on one of the lid’s semicircular bulges.

3. At the same time fold up the lid on the opposite side from the hook of the basket.

4. Pull the lid up from the basket.

The respirator is separated from the lid by squeezing the tabs on the underside of the lid.

! Do not shake the parts when dissembling.

! The adjustment ring should be pulled straight out of the respirator.

You can read more about the product and how to use it in the WellO2 user manual:https://wello2.com.au/pages/instructions

If you have any questions please contact:Jonas.pilhage@wello2.com.au

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>